Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: cwill144 on 07 December 2009, 07:56:35

Title: MV6 Clutch pipe - engine removal
Post by: cwill144 on 07 December 2009, 07:56:35

While removing the engine & gearbox in MV6 what is the correct way of dis-connecting the hydraulic clutch pipe? I have traced the flexi pipe to the connector on the bulkhead but am unsure how to undo it and how to plug it to stop losing any fluid?

Title: Re: MV6 Clutch pipe - engine removal
Post by: Elite Pete on 07 December 2009, 08:32:32

There is an L shaped sliding clip once removed the pipe just slides apart.

Title: Re: MV6 Clutch pipe - engine removal
Post by: Matchless on 07 December 2009, 13:38:06

More of a U shape iirc, but a simple bit of bent springy wire that sits in a groove around the connector. Finger nail or small screwdriver to get it out then twist the flexipipe slightly and it should pull out.
Access is (as usual) less than optimum

Title: Re: MV6 Clutch pipe - engine removal
Post by: unlucky mark mv6 on 07 December 2009, 13:44:11

Quote

More of a U shape iirc, but a simple bit of bent springy wire that sits in a groove around the connector. Finger nail or small screwdriver to get it out then twist the flexipipe slightly and it should pull out.
Access is (as usual) less than optimum

I beleive you are the one that done the manual conversion write up in the maintainence section mate.Does this apply to the facelift aswell,and maybe picking your brains aswell in the near future. ;D ;D :y