Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: metroman on 17 December 2009, 16:38:48

Title: Omega V6 engine bay wiring
Post by: metroman on 17 December 2009, 16:38:48

I've just replaced the Thermostat on a V6 Omega B, on putting everything back together I've got a lonly plug, I'm sure I've missed something?? the plug is coming from the loom on the N/S bank near the dipstick, I cant find a wire to plug into it and I have totally forgotten if it was or not plugged in before, a picture could be really handy, it's the short Male plug that comes from the loom???? just hope it's not under the manifold!!!

Title: Re: Omega V6 engine bay wiring
Post by: Bionic on 17 December 2009, 16:41:54

Sure its not from the bonnett open sensor for the alarm?

Title: Re: Omega V6 engine bay wiring
Post by: metroman on 17 December 2009, 16:42:44

plugged in, not that one?

Title: Re: Omega V6 engine bay wiring
Post by: andyc on 17 December 2009, 16:46:58

Knock sensor? and the harness from the sensor has dropped down the side of the block


Andy

Title: Re: Omega V6 engine bay wiring
Post by: JamesV6CDX on 17 December 2009, 16:48:49

Cam sensor

Knock Sensor

Throttle Position Sensor

Title: Re: Omega V6 engine bay wiring
Post by: tigers_gonads on 17 December 2009, 17:23:53

does it start ?

Title: Re: Omega V6 engine bay wiring
Post by: tigers_gonads on 17 December 2009, 17:25:04

how many pins ?

Title: Re: Omega V6 engine bay wiring
Post by: metroman on 17 December 2009, 17:53:06

to dark to count pins at mo, yes it does start and run, I know it's not the cam sensor ( that plugs at the end of the loom ), and it's not the TPS either, I'm actually thinking knock sensor mite be a option, I'm going to have a look in the morning, I blame it for being cold

Title: Re: Omega V6 engine bay wiring
Post by: tigers_gonads on 17 December 2009, 17:55:08

on the wiring cage that runs down the right hand side of the engine
where does it come out ?
front / mid or back of the cage ?

Title: Re: Omega V6 engine bay wiring
Post by: tigers_gonads on 17 December 2009, 17:55:34

any eml light ?

Title: Re: Omega V6 engine bay wiring
Post by: mantahatch on 17 December 2009, 18:01:34

Back of the idle control valve ? silver thingy on n/s of plenum.

Title: Re: Omega V6 engine bay wiring
Post by: metroman on 17 December 2009, 18:07:02

the easiest way to explain is where the main part of the loom heads towards the fusebox its underneath that, there is currently a EML light on ( code read it in the morning now ) but this maybe down to a problem on the cam sensor, it got caught on removal,

Title: Re: Omega V6 engine bay wiring
Post by: metroman on 17 December 2009, 18:08:10

ICV all working fine and plugged in ( not that type of connector anyway )

Title: Re: Omega V6 engine bay wiring
Post by: tigers_gonads on 17 December 2009, 18:09:01

read the codes and come back in morning mate  :y

should be a piece of pish then  :y