Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: sparkyw666. on 18 January 2010, 14:20:32

Title: how to ?
Post by: sparkyw666. on 18 January 2010, 14:20:32

right putting in new rear wheelbearings this week . The question is how do you get the hubs back through with out the inner race popping out the back when you put it through ? :y

Title: Re: how to ?
Post by: RobG on 18 January 2010, 14:31:20

Have a read of this mate, you may change your mind
http://www.omegaowners.com/forum/YaBB.pl?num=1186653928/0

Title: Re: how to ?
Post by: sparkyw666. on 18 January 2010, 14:48:29

Quote

Have a read of this mate, you may change your mind
http://www.omegaowners.com/forum/YaBB.pl?num=1186653928/0

to late hubs out .bearings out . Think bearing will go in ok just dont want f**k the bearings putting the hubs back through :y

Title: Re: how to ?
Post by: al brown on 20 January 2010, 16:18:14

Did you fit it yet? I used a reaction block on the inside when I knocked the bearing in to stop the inner race falling out.
Al