Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: caran10 on 21 January 2010, 22:17:36
-
got yet another problem with my miggy
just come back from having a new power steering pump fitted car ran fine but cut out a couple of times then seemed ok apart from sudden loss of power which cleared and ran ok . Parked car at home ,went out about 2 hours later and it wont start , turning over but not firing dont know wether the immobiliser is playing up can it be disconnected hope someone can help
-
got yet another problem with my miggy
just come back from having a new power steering pump fitted car ran fine but cut out a couple of times then seemed ok apart from sudden loss of power which cleared and ran ok . Parked car at home ,went out about 2 hours later and it wont start , turning over but not firing dont know wether the immobiliser is playing up can it be disconnected hope someone can help
Dont think it would even turn over if it was the immobiliser iirc. :-/
-
is the engine management light on, we will need to know if any codes are coming up. :y
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
dont know of hand could be a snaped elastic band ;)
-
Do the pedal trick test - similar issues on my 2002 2.6 - turns over but doesn't fire - cuts out when up to operating temp... pedal trick showed crank sensor fault.
Bought the sensor and having it fitted on Saturday (along with a few other bits Daz is sorting out... ) :y
Hope it is that as car hasn't really been driven in the month since it's been bought....
-
Do this http://www.omegaowners.com/forum/YaBB.pl?num=1189022687 :y
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
would faulty crank sensor prevent it starting
-
yes and others will as well, do test first. :y
-
yes and others will as well, do test first. :y
ok will try that tomorrow and keep my fingers crossed will it run if you disconnect the sensor or is that a stupid question
-
dont mater if gone or removed still wont start.
-
yes and others will as well, do test first. :y
ok will try that tomorrow and keep my fingers crossed will it run if you disconnect the sensor or is that a stupid question
Nope... Wont do anything other than turn over ;) ;)
If it is the sensor, only use genuine Vx part :y :y
Do the test and post the results :y
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
done the pedal trick comes up 0100 0335 162
dont know what 162 is cant find details of this code anywhere
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
done the pedal trick comes up 0100 0335 162
dont know what 162 is cant find details of this code anywhere
There`s your answer then. Crank sensor
-
got yet another problem with my miggy
just come back from having a new power steering pump fitted car ran fine but cut out a couple of times then seemed ok apart from sudden loss of power which cleared and ran ok . Parked car at home ,went out about 2 hours later and it wont start , turning over but not firing dont know wether the immobiliser is playing up can it be disconnected hope someone can help
Dont think it would even turn over if it was the immobiliser iirc. :-/
Yes it would
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
done the pedal trick comes up 0100 0335 162
dont know what 162 is cant find details of this code anywhere
Yep... Crank sensor. Ignore the other codes until you've done the C/S as it's quite common for the C/S fault to throw up some other strange codes ;) ;)
Use genuine Vx part only :y :y
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
done the pedal trick comes up 0100 0335 162
dont know what 162 is cant find details of this code anywhere
Yep... Crank sensor. Ignore the other codes until you've done the C/S as it's quite common for the C/S fault to throw up some other strange codes ;) ;)
Use genuine Vx part only :y :y
canyou tell me where the connector is for the c/s took off what i thought and it has 2 pins in the connector got the new one from vauxhall dealer and it has got 3 and where is the crank sensor
-
Last pic http://www.omegaowners.com/forum/YaBB.pl?num=1181719948 :y
-
Will the pedal trick work?
Bet it's the crank sensor ::) ;)
done the pedal trick comes up 0100 0335 162
dont know what 162 is cant find details of this code anywhere
Yep... Crank sensor. Ignore the other codes until you've done the C/S as it's quite common for the C/S fault to throw up some other strange codes ;) ;)
Use genuine Vx part only :y :y
canyou tell me where the connector is for the c/s took off what i thought and it has 2 pins in the connector got the new one from vauxhall dealer and it has got 3 and where is the crank sensor
sorted crank sensor out c ar runs again although still cuts out occassionaly on low revs and doesnt seem to be running smooth did pedal test again and still getting codes 0100 0335 1512 is this normal , do they have to be removed manually