Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: raywilb on 23 January 2010, 17:39:34

Title: vx griffin
Post by: raywilb on 23 January 2010, 17:39:34

obtained boot catch from scrapper, but had to remove griffin badge to change colour. ideas wanted pls on sticking it back on.  :y

Title: Re: vx griffin
Post by: rustym95 on 23 January 2010, 18:10:39

i used plastic glue still on 2 years on :y

Title: Re: vx griffin
Post by: Bionic on 23 January 2010, 18:11:19

I use double sided decal tape. You should be able to beg a bit from a body shop cos it comes on a 5M roll 50mm wide x 1mm thick. All I do is peel the backing off stick the badge on and then use a thin craft knife to cut away the excess.
I ended up buying a roll from GE Factors.
I know others have used builders silicon and even bluetack but decal tape is the correct method.
GudLuk

Title: Re: vx griffin
Post by: waspy on 23 January 2010, 18:22:06

PM me your address & i'll send you some double sided tape for the job :y

Title: Re: vx griffin
Post by: raywilb on 23 January 2010, 18:39:43

de-cal tape sounds ok, as does plastic glue. thanks loads Pete for the offer but i,m sure by tomorrow i,ll be sorted. as for silicone i,ve tubes of the stuff but was concerned re hot days.  :y :y

Title: Re: vx griffin
Post by: pedroMV6 on 23 January 2010, 20:58:01

Quote

de-cal tape sounds ok, as does plastic glue. thanks loads Pete for the offer but i,m sure by tomorrow i,ll be sorted. as for silicone i,ve tubes of the stuff but was concerned re hot days.  :y :y

No need fella - once set it'll withstand silly hight temps! :y

Title: Re: vx griffin
Post by: goonv6 on 23 January 2010, 21:26:15

Epoxy resin as well. Can't go wrong!

Title: Re: vx griffin
Post by: webby23 on 23 January 2010, 22:12:55

Superglue mate, held most of my old Minis together......!!!

 :y