Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: caran10 on 24 January 2010, 12:37:12
-
my miggy keeps cutting out at low revs and seems to hesitate when accelerating , seems to improve when warm although still cuts out when idling. just changed crank sensor .
-
check the idle control valve. but that would bring a code up. you say you canged the crank sensor have you put all the vac pipes on and pluged all the sensors in.
-
check the idle control valve. but that would bring a code up. you say you canged the crank sensor have you put all the vac pipes on and pluged all the sensors in.
2.6 does not have ICV, was the crank sensor geniune?
Do the Pedal test to get some codes :y
-
weather the part was gm or not dosent make a lot o differernce as only bosch and siemans make them.
-
weather the part was gm or not dosent make a lot o differernce as only bosch and siemans make them.
Lot of people have had issues with pattern sensors, which was fixed by genuine sensors.
Caran needs to get the codes read!
-
check the idle control valve. but that would bring a code up. you say you canged the crank sensor have you put all the vac pipes on and pluged all the sensors in.
2.6 does not have ICV, was the crank sensor geniune?
Do the Pedal test to get some codes :y
pedal test comes up 0100 0335 1512 thge same as before i changed the crank sensor i sort of had this problem before the crank sensor packed up . used genuine v/w replacement
-
0335 crank sensor. I put a new crank sensor on the saloon - genuine Vx from main dealer - lasted less than a month!! Replaced with a used one I had - ok since!!
-
0335 crank sensor. I put a new crank sensor on the saloon - genuine Vx from main dealer - lasted less than a month!! Replaced with a used one I had - ok since!!
only fitted new one yesterday wouldnt run at all before
-
Could still be a dodgy one - code should clear if all is well with crank sensor.
-
my miggy keeps cutting out at low revs and seems to hesitate when accelerating , seems to improve when warm although still cuts out when idling. just changed crank sensor .
cuts out every time i stop, give it some welli and it seems to clear for a while but then plays up again as if i have a fuel blockage
-
my miggy keeps cutting out at low revs and seems to hesitate when accelerating , seems to improve when warm although still cuts out when idling. just changed crank sensor .
-
my miggy keeps cutting out at low revs and seems to hesitate when accelerating , seems to improve when warm although still cuts out when idling. just changed crank sensor .
-
my miggy keeps cutting out at low revs and seems to hesitate when accelerating , seems to improve when warm although still cuts out when idling. just changed crank sensor .
cuts out every time i stop, give it some welli and it seems to clear for a while but then plays up again as if i have a fuel blockage
-
When you fitted the crank sensor, did you make sure it was routed away from the exhaust manifold and heat shield - as best as possible (due to the short length of cable that comes with the sensor)?
Good pictures here from Mark here:
http://www.omegaowners.com/forum/YaBB.pl?num=1263833502/10#10
Wondering if the new one has developed a fault straight due to the cable running to close to the hot parts…
-
[quote author=5F7B7B797B66647C140
Good pictures here from Mark here:
http://www.omegaowners.com/forum/YaBB.pl?num=1263833502/10#10
Wondering if the new one has developed a fault straight due to the cable running to close to the hot parts…
[/quote]
yes fitted the new sensor well away from any heat
did a tech 2 test today which showed lots of old faults . wiped them clean and did all the tests again and no faults showed . running better but still cutting out occasionaly on low revs ,wonder if i have some dirt in fuel , also did a pedal test and the light kept flashing continuously ,is this normal and means no faults ?