Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: d737 on 29 January 2010, 13:07:31

Title: re-set after paper clip test
Post by: d737 on 29 January 2010, 13:07:31

had fault on inlet manifold sensor, can you re-set in order to get the warning light off?

Title: Re: re-set after paper clip test
Post by: RobG on 29 January 2010, 13:08:51

If the fault has been cured, should go off.

Title: Re: re-set after paper clip test
Post by: jonathanh on 29 January 2010, 13:14:48

20 clean starts: turn ignition on, not need to get engine turning over, but let the self check sequence work, repeat.  Maybe 30 times - I can never remember

Title: Re: re-set after paper clip test
Post by: Entwood on 29 January 2010, 14:09:23

Put your location in your profile ...  might have someone nearby with the relevant equipment who can help .. :)

Title: Re: re-set after paper clip test
Post by: Andy B on 29 January 2010, 14:23:48

Quote

20 clean starts: turn ignition on, not need to get engine turning over, but let the self check sequence work, repeat.  Maybe 30 times - I can never remember

If the fault has been fixed, the EML will go out straight away but, if you checked for the codes, the fault code would still appear because it gets stored in the ECU until it's either cleared with a code reader or you've made 20/30 'clean' starts  ;)  ;) :y

Title: Re: re-set after paper clip test
Post by: TheBoy on 29 January 2010, 18:58:47

Quote

20 clean starts: turn ignition on, not need to get engine turning over, but let the self check sequence work, repeat.  Maybe 30 times - I can never remember

Clean starts needed. Ign on not enough.