Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Road Hog Mad on 14 February 2010, 14:06:12
-
Ok, so following on from changing the spark plugs in my friends Omega 3.0 Elite and then the Engine Management Light coming on. I now have been up and recorded the light flashing, video here... http://www.youtube.com/watch?v=mPk4qBKrRsE I can't seem to follow what it is doing, I require once again help from the people in the know. Maybe one day I can repay the favour?
-
Code 59, intake manifold valve 1. Make sure the connector at the back of the plenum, passenger side is plugged into the small solenoid valve.
-
you move the camera out of the way half way through can't see it. you count the number of flashes, eg flashes 3 times, pause, then 4 times, that gives code of 31.
-
code 59 code 57 code 94 code 19 :-/
-
lol. Errr.... I don't know what the hell that is lol.
Here's a picture of a 3.0 litre engine but not the same engine, can you guide me on this?
http://img707.imageshack.us/img707/3642/16122008433.jpg
Also another question, can the ABS ECU be taken out of the car and the car still run? obviously the ABS light and TC light will be on, but its on anyway while I source another one?
-
you move the camera out of the way half way through can't see it. you count the number of flashes, eg flashes 3 times, pause, then 4 times, that gives code of 31.
I know, the sun roof opened by itself I looked up, other guy said it was code 59?
-
codes here:
http://www.omegaowners.com/forum/YaBB.pl?num=1160152415
-
I did try a few spare sensors on it to see if it cured it, can you make it clear and then come back on the get the correct error code?
-
Code 59, intake manifold valve 1. Make sure the connector at the back of the plenum, passenger side is plugged into the small solenoid valve.
any pics of where this is? :y
-
bump
-
No pics but it controls the rear multi-ram so look in that area pass. side http://www.omegaowners.com/forum/YaBB.pl?num=1266072249
-
Went round today to have a look, the wire had come off, plugged it back in and fired her up, no engine management light on. Very Pleased lol. Just need to source an ABS ECU now lol