Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: gateshead on 28 February 2010, 20:27:04
-
is there a there a how to change a thermostat guide on here my temp gauge does not seem to move
-
yes, try the index in the top of the maint section, or my sig...
http://www.omegaowners.com/forum/YaBB.pl?num=1229464812
assuming you have a v6 ;)
-
my mind reading element has burned out and not working today, what engine? ::)
-
yes sorry guys would help 2.5td
-
as it got aircon :y :y
-
yes
-
don't know much about the TD, but does the needle move even just a bit?
-
it moves just off the bottom but it does not shove out anuff hot air even to demist the window i drove the car 20 miles and the heaters were blowing out coolish air
-
drain rad, little red plug thing passenger side at the bottom, drain clyinder head (bolt in head above the turbo) with it not having aircon no need to take viscous fan off,take hose off thremostat housing,unscrew the three 10mm bolts what keep housing on,replace thomostat plus o ring tighten the three bolts evenly to 8nm,refill header tank with 50/50 mix with antifreeze/water, put heating on full leave the cap off the header tank,start car and press the hoses to get the air out of the system :y :y
-
it should say take viscous fan off.Its got aircon :y
-
thanks charlie. does the coolent system not need to be bleeded on the engine or rad someware
-
the thermostat got a nipple on to self bleed,putting the aircon on hi setting with fans at max,while pressing the hoses gets whatever air left in there out ::)
-
you must bleed the system as soon as youv'e refilled water in header tank