Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: sc00bi on 08 April 2010, 14:36:17

Title: advice plz :)
Post by: sc00bi on 08 April 2010, 14:36:17

hi all,

just had the front brakes done- new pads..

now i get "brake pads" message on the display... how do i get rid of this message?

Title: Re: advice plz :)
Post by: RobG on 08 April 2010, 14:41:22

Obviously wear sensors were removed and not replaced with new. Fit new sensors or splice the two wires on each of the connectors to eradicate the fault message. Connector just to the right of droplink (black bar) in this pic http://www.omegaowners.com/forum/YaBB.pl?num=1219190177

Title: Re: advice plz :)
Post by: tunnie on 08 April 2010, 16:07:26

you either broke or did not replace the sensors that clip onto the pads

Title: Re: advice plz :)
Post by: Andy B on 08 April 2010, 16:09:50

Quote

hi all,

just had the front brakes done- new pads..

now i get "brake pads" message on the display... how do i get rid of this message?

If I'd paid someone else to do the job fro me, I'd be asking the garage I'd just paid the question!   ;)  ;)

Title: Re: advice plz :)
Post by: Lazydocker on 08 April 2010, 16:14:43

Quote

Quote

hi all,

just had the front brakes done- new pads..

now i get "brake pads" message on the display... how do i get rid of this message?

If I'd paid someone else to do the job fro me, I'd be asking the garage I'd just paid the question!   ;)  ;)

Me too ;) ;)

But, if they can let it go with a fault showing I'm not sure I'd be happy to go back :-/

Title: Re: advice plz :)
Post by: Andy B on 08 April 2010, 16:23:26

Quote

....
But, if they can let it go with a fault showing I'm not sure I'd be happy to go back :-/

I know I'd never go back again if they fobbed me off re the fault message.  :y