Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: RobseyMV6 on 08 May 2010, 16:53:50
-
Did a paper clip test on a 3.0 manual facelift 2000 as dash clocks die and abs and tc come on, could this be code 31, no engine RPM signal, where do i find the problem for this?
Thanks :y
-
If you do the test with the engine running you will not get the code as the sensor is getting a signal.
-
If you do the test with the engine running you will not get the code as the sensor is getting a signal.
Ok so not 31 that is the problem?
-
paper clip test & pedal trick only do engine codes. ;)
-
Sounds like the dreaded ABS ECU to me :(
-
12 is start/end of test
31 is normal with engine off as crank shaft sensor is obviously not getting a signal
both TC and ABS lights on and speedo not working is 99% certainly TC/ABS ECU failed or 1% both sensors not working...
-
12 is start/end of test
31 is normal with engine off as crank shaft sensor is obviously not getting a signal
both TC and ABS lights on and speedo not working is 99% certainly TC/ABS ECU failed or 1% both sensors not working...
Cleaned and replaced rear diff sensors no change :(
Boy i hope its not the ecu brake unit :'( what a night mare to do!!
-
AS above - dying abs ecu most likely :(
Awkward job to do but doable :y
-
AS above - dying abs ecu most likely :(
Awkward job to do but doable :y
Think it maybe better to remove engine to do the job!
-
AS above - dying abs ecu most likely :(
Awkward job to do but doable :y
Think it maybe better to remove engine to do the job!
nah, easy for you Rob, iirc there is a guide.
-
Its a piece of cake mate...just bend the unit up towards you a little as the brake pipes have some flexibility and the screws holding the ECU in place are easy to get to to remove and put back :y
-
Thanks will have to see? its my brothers and now he wants to sell it!! i'll do the work for nothing...