Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: coastie123 on 17 May 2010, 15:57:50

Title: Code questions
Post by: coastie123 on 17 May 2010, 15:57:50

Hi guys

over the last 2/3 weeks I have had a few different codes pop up

a few weeks ago I had 135 which has now dissspeared and now showing code 19.

Could these be stored codes popping up at random?? I dont have any issues at all with the car

please note that the cambelt was done last week..

Title: Re: Code questions
Post by: Zuffenhausen on 17 May 2010, 16:00:48

19 is incorrect RPM signal - crank sensor could be faulty.

Title: Re: Code questions
Post by: coastie123 on 17 May 2010, 16:03:15

I looked up the code number...

Could this have gone faulty after changing the cambelt??? Where will I find this little beauty then??

Surely if the crank sensor was faulty, there would be an issue with the car??

Title: Re: Code questions
Post by: Psychoca on 17 May 2010, 20:20:00

Assuming that it is in a similar place to the TD, it is on the flywheel housing, just below the starter motor.

When I had problems with the crank sensor, the only symptom I had was that the engine was very difficult to start, which turned out to be the starter motor had worked loose and was causing interference with the sensor...

Title: Re: Code questions
Post by: Elite Pete on 17 May 2010, 20:37:06

Quote

I looked up the code number...

Could this have gone faulty after changing the cambelt??? Where will I find this little beauty then??

Surely if the crank sensor was faulty, there would be an issue with the car??

Its just above the oil filter and the plug is near the dis pack. The crank sensor will sooner or later give up all together and then the car won't start.

Title: Re: Code questions
Post by: Andy H on 17 May 2010, 20:38:17

19   Incorrect RPM Signal
31   No Engine RPM Signal
135   Telltale (Checklight) Voltage Low

The crank position sensor on a V6 is behind the oil filter on the passenger side.

Title: Re: Code questions
Post by: TheBoy on 17 May 2010, 21:01:51

that crank sensor needs changing before it lets you down

Title: Re: Code questions
Post by: coastie123 on 17 May 2010, 21:19:05

Thanks for all your replies, payday Thursday so will be visiting the stealers then...

Thanks for all your help..