Omega Owners Forum
		Omega Help Area => Omega General Help => Topic started by: sjc on 31 May 2010, 14:20:26
		
			
			- 
				Was removing an old hands-free kit and had to take the climate control panel off to detach the phone cradle.
 
 Found this lying on top of the wiring loom not attached to anything - it was quite badly bent, I've straightened it out.
 
 Looks like a link rod to me, but where should it go and what does it do?  Climate seems to work fine.
 
 Anyone know?
 
 (http://img4013.photobox.co.uk/77621284e28dc40bd344d479b29fef35f5193f3937390096251b80d4a12a473feae0fe62.jpg)
 
 Cheers,
 Stephen
 
- 
				err?
 I give in ........ what is it?  ;)  ;)  ;)
 
 presumably an operating rod for heat/direction flaps
- 
				err?
 I give in ........ what is it?  ;)  ;)  ;)
 
 presumably an operating rod for heat/direction flaps
 
 You were too quick!  I hadn't finished - was just checking the photo was showing ok.
 
 ;D
- 
				As far as I can remember, this rod connects left and right side flap for the defroster (only one servo for this).
 
 Edit: I have to stop idling when writing posts :p
- 
				As far as I can remember, this rod connects left and right side flap for the defroster (only one servo for this).
 
 Edit: I have to stop idling when writing posts :p
 
 Is it easy/possible to put back, I couldn't see any obvious place for it to go so I'm guessing it's away up the back somewhere   :'(
 
- 
				I'm not sure how easy it is. A mate of mine put it back together (as it was his car). I can try to find some instructions for it when I get home, it might be visible in the Haynes book.
			
- 
				I'm not sure how easy it is. A mate of mine put it back together (as it was his car). I can try to find some instructions for it when I get home, it might be visible in the Haynes book. 
 That would be magic, cheers.  Will check the Haynes book, but going by how utterly deficient their description/pictures of how to remove the climate control fascia panel is, I'm not overly optimistic!  It has a photo of a hand going into the radio hole but not one of the release lever for the panel - WTF!!!
 (found a pic on here of course  :y)