Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: omegasport on 06 June 2010, 14:22:54

Title: maybe crank sensor help
Post by: omegasport on 06 June 2010, 14:22:54

hi again thank you to all of those that helped me with my car ive dodne a paper clip test it flashed 12 3 times and code 19 3 times then went back to code 12 but during all of this the engine was off with ignition on was this the correct way to do it

thanks 

Title: Re: maybe crank sensor help
Post by: omegasport on 06 June 2010, 14:55:12

also how do u wipe the codes to see if it comes back as code 19 or does that have to be done at a garage

thanks

Title: Re: maybe crank sensor help
Post by: Varche on 06 June 2010, 14:58:18

I understand the fault code remains for about 20 clean starts following you fixing the problem.

I understand that a Tech2 analyzer can clear the codes when plugged in.

Title: Re: maybe crank sensor help
Post by: RobG on 06 June 2010, 15:44:40

Has the crank sensor been changed :question

Title: Re: maybe crank sensor help
Post by: omegasport on 06 June 2010, 15:53:19

hi no the crank sensor has never been touched

Title: Re: maybe crank sensor help
Post by: RobG on 06 June 2010, 16:45:06

What symptons are/do you get :question

Title: Re: maybe crank sensor help
Post by: omegasport on 06 June 2010, 17:04:36

hi im getting very uneven running when cold and it gets a little better when hot but still joggy and rev counter moves up and down a tad but asoon as u press the trottle smooth as u like and very nippy  i done a papaer clip test and got code 19

thanks

Title: Re: maybe crank sensor help
Post by: RobG on 06 June 2010, 17:14:44

Any probs starting from warm/hot. Code 19 is crank sensor, replace with genuine
 
2.6/3.0/3.2                                  90540743 £55.00 £49.56 £42.63

 


 

Title: Re: maybe crank sensor help
Post by: albitz on 06 June 2010, 17:27:29

Crank sensor on the way out.If you dont change it soon (follow the guide in the guides section, 10 minute job) the car will suddenly stop and it wont go again until sensor is changed. ;)

Title: Re: maybe crank sensor help
Post by: omegasport on 06 June 2010, 18:36:46

hi i think im getting confussed when i did the first check with paper clip i briged pins 5 and 6 according to top buzz website and got code 19 and when i followed instructions from this site it saying use a diffrent pin to 6 its the next 1 down i think pin 7 so i did that and now getting code 61 fuel tank vent valve what the hell is that im getting confussed can anyone please tell me where im going wrong

thanks

Title: Re: maybe crank sensor help
Post by: Andy H on 06 June 2010, 20:21:04

Are you sure? It looks as if pins 4 & 6 are being bridged here.

Pin 4 is vehicle ground and pin 5 is signal ground. Either seems to work when used to pull pin 6 low to trigger the flash codes.

I don't know if there is another controller linked to pin 7. :-/ If there is you would want to find out what it is and what the fault codes mean for that controller.

(http://images.omegaowners.com/images/guides/paperclip_test/IMG_2219.JPG)