Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: BRIGSPORT on 02 September 2010, 18:12:22

Title: TD ar35 torque settings
Post by: BRIGSPORT on 02 September 2010, 18:12:22

What are the torque settings to use when changing bell housings, and also tightening sequence? Thanks.

Title: Re: TD ar35 torque settings
Post by: Kneepad on 02 September 2010, 19:00:44

Torque
3 upper screws for converter housing to engine – 60 Nm / 44 lbf. ft. 2 screws  for starter to engine – 40 Nm / 29.5 lbf. ft.
Cover plate to converter housing (1 screw) – 5 Nm / 3.7 lbf. ft.
Converter to drive plate (3 screws) – 55 Nm / 40.5 lbf. ft. Insert cover cap.
 
4 lower fastening bolts  to converter housing (M8) – 20 Nm / 15 lbf. ft.
4 lower fastening bolts  to converter housing (M10) – 40 Nm / 29.5 lbf. ft.
1 lower fastening bolt  to converter housing – 60 Nm / 44 lbf. ft.

No tightening sequence given but if you go to diagonally opposing bolt you won't go wrong.   :y

Title: Re: TD ar35 torque settings
Post by: BRIGSPORT on 02 September 2010, 20:13:59

Thank you very much. :y