Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: skyblue on 03 September 2010, 21:38:54

Title: Cable tray
Post by: skyblue on 03 September 2010, 21:38:54

This might be a stupied question but please bare with me for a mo.

I have been following the guide on changeing the cam covers on a V6 (replaceing mine  again) and have noticed that this tray cant be seen over the passenger side cam cover itself.... is there a way of disconecting it  so it can be moved out of the way while im refitting the cam cover ( as mine at the mo is right in the way )

Title: Re: Cable tray
Post by: Jinglemaster2 on 03 September 2010, 21:54:27

You can disconnect it, but I always found the easiest thing is to ease the loom out of the cable ducting, and remove the plastic ducting completely. This leaves a lot more room to see and get the P/S cover removed and replaced.

Title: Re: Cable tray
Post by: skyblue on 03 September 2010, 22:03:05

Quote

You can disconnect it, but I always found the easiest thing is to ease the loom out of the cable ducting, and remove the plastic ducting completely. This leaves a lot more room to see and get the P/S cover removed and replaced.

Thanks for ya reply ..... where can I disconnect it  from  ???? as I noticed there is a plug at the back of the engine  compartment but the other wire disappears into the depths of the unknown  :-? :-/

Title: Re: Cable tray
Post by: Elite Pete on 03 September 2010, 22:16:43

There are little tags along the top, so have to undo them with a thin screwdriver and the lid will come off ;)

Title: Re: Cable tray
Post by: tidla on 03 September 2010, 22:32:09

use cable ties to lift it toward the bonnet and keep it there.

Title: Re: Cable tray
Post by: skyblue on 03 September 2010, 22:36:08

Thanks again for the advice.... this could save me a packet  in donations to the  sweartin  ;) :)