Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: MadMark73 on 20 September 2010, 09:38:47

Title: Fault code advice.
Post by: MadMark73 on 20 September 2010, 09:38:47

After being told the wifes omega is not running properly ( she says it is pulling back and not revving as normal) and the ecu light is on intermitantly I have just paperclipped it and got these codes.

129   Exhaust Gas Recirculation (EGR) Valve Feedback Voltage Low
 
132   Exhaust Gas Recirculation (EGR) Valve Feedback Incorrect Signal

135   Telltale (Checklight) Voltage Low

Any advice on what the next step is would be greatly appreciated.
MadMark73

Title: Re: Fault code advice.
Post by: Marks DTM Calib on 20 September 2010, 11:02:05

Next step would be to confirm the engine type or is it the V6 mentioned in your profile (not clear as you mention wife).

If it is the V6 then remvoe the EGR valve and clean the pintle section with some oven cleaner and actuate the pintle valve a few times whilst doing so.

Then when re-fitting, fit a blanking plate

Title: Re: Fault code advice.
Post by: MadMark73 on 20 September 2010, 11:29:44

Sorry. Its a 2.5 v6.

Title: Re: Fault code advice.
Post by: Marks DTM Calib on 20 September 2010, 11:43:40

Ok, so do as per above  :y

Title: Re: Fault code advice.
Post by: MadMark73 on 20 September 2010, 13:24:18

Where would a blanking plate be acquired?

Title: Re: Fault code advice.
Post by: RobG on 20 September 2010, 13:25:58

From VX or make one from a coke can ;)
http://i3.photobucket.com/albums/y99/issunaz/Hpim1049.jpg

Title: Re: Fault code advice.
Post by: Jimbob on 20 September 2010, 13:44:22

coke cans just melt in a short time, needs to be more substantial