Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: dpk76 on 16 December 2010, 16:27:34
-
hi all,i have a 2001 3.0 elite.heaters wont blow hot,checked pipes to matrix on hot one cold.flushed matrix still the same.any ideas it could be anything else but matrix?thanks
-
Remove & plug vac hose on top of HBV and see if you get heat then
-
hi rob ive tried that and still same.also tried flushing matrix out.wondering possible air lock?just trying things before i go and try new matrix
-
You need to flush the matrix both ways several times. If you connect a piece of hose to each pipe in the engine bay can you blow through one and get air through?
-
both pipes to matrix are hot now but still no heat.took vacum pipe off heater valve still nowt.doesnt seem to be much if any vacum from pipe?
-
Hi had this problem on a 2lt have you checked your thermastat, if it ok then it could be your water pump. as it was the later on mine .
-
Hi everyone,
I have a similar problem with my car although i am getting hot air in to bak of car just not the front. Anyone know what i should check or do?
-
have not tried thermo yet but car seems to running at about 80 85 which i think may be bit below but i thought it would run less if it was thermo?
-
Hi had this problem on a 2lt have you checked your thermastat, if it ok then it could be your water pump. as it was the later on mine .
Unlikely. If this has failed you will overheat big-time. :y
-
someone said possible heater ucu???anyone had this problem before?