Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: Justanother Dave on 15 January 2011, 09:48:48

Title: No heat fromheater
Post by: Justanother Dave on 15 January 2011, 09:48:48

Hi Guys,
Had my MV6 a few days now, but only just noticed the heaters don't provide any heat at all.Is there anything I should be checking first?
The fans work, but the air coming through seems to be about the same as the outside temp. The coolant level is at max, the gauge sits in the middle (around 80).

Thanks in advance.

Title: Re: No heat fromheater
Post by: Ben1976 on 15 January 2011, 09:54:30

It may be the heater matrix, I'm having the same problem but mine looks like it's down to the head gasket as the car is over heating, I may be wrong see what other people say ok

Title: Re: No heat fromheater
Post by: Darth Loo-knee on 15 January 2011, 11:26:14

The HBV has a small vac pipe that goes from the top of the HBV into the Bulkhead. If this is not on no heat will be in the cabin.

Clean out the Heater Matrix by pulling off the top and bottom pipes then running the garden hose through the top then the bottom until bothways the water is coming out nice and freely plus clean :y

Title: Re: No heat fromheater
Post by: Entwood on 15 January 2011, 11:35:31

Quote

The HBV has a small vac pipe that goes from the top of the HBV into the Bulkhead. If this is not on no heat will be in the cabin.

Clean out the Heater Matrix by pulling off the top and bottom pipes then running the garden hose through the top then the bottom until bothways the water is coming out nice and freely plus clean :y

Thought it was the other way round ???

Pipe off (and blocked to hold vac) gives max flow through matrix ??? ISTR thats what I did last winter when I had HBV sticking problems ...


 :)

Title: Re: No heat fromheater
Post by: RobG on 15 January 2011, 11:37:27

Quote

Quote

The HBV has a small vac pipe that goes from the top of the HBV into the Bulkhead. If this is not on no heat will be in the cabin.

Clean out the Heater Matrix by pulling off the top and bottom pipes then running the garden hose through the top then the bottom until bothways the water is coming out nice and freely plus clean :y

Thought it was the other way round ???

Pipe off (and blocked to hold vac) gives max flow through matrix ??? ISTR thats what I did last winter when I had HBV sticking problems ...


 :)

Correct. (pink moment) ;D ;D

Title: Re: No heat fromheater
Post by: Darth Loo-knee on 15 January 2011, 12:18:00

Could have sworn it gets no heat when that vac hose was off . .  Icould be wrong though.   :P

Title: Re: No heat fromheater
Post by: Justanother Dave on 16 January 2011, 12:49:15

Thanks for your help guys, I'll give that a go.

I just wish the pictures would load from the site so I could see the maintenance guides. 

Title: Re: No heat fromheater
Post by: Justanother Dave on 20 January 2011, 14:41:07

An update - I have just done the matrix flush as suggested, and kindly detailed in the maintenance section. Toasty warm car, thank you guys!