Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: mariusz on 12 January 2011, 12:32:52
-
hi,my omega W reg after facelift have problem.RPM to low 670rpm,and engine try to off.i put new throtlle position sensor and cleaned throtlle and idle control.But after fe dys engine code P0505-too high.Where is the problem?car driving nice,just when I stop is horible.
Maybe someone have tech2 to setup my rpm higher?Or any idea??
-
P0505 Idle Air Control Voltage High
P0505 Idle Air Control Voltage Low
Suggests your IAC is not happy, try cleaning the connector, may want replacing.
also, any air leaks? spray carb cleaner around the engine, if the engine rev changes, youve found a leak.
-
what kind carb cleaner??
-
I,v done and notfing find.
Maybe someone can change my rpm to higher??? ;D
-
When you cleaned the throttle and idle valve, did you also clean the small breather jet as described in Grumpy's "How To" (http://www.omegaowners.com/forum/YaBB.pl?num=1194007453) ?
In my experience - although I can't properly explain why - if that jet is not clear, the idle will be lower than it should be.
-
I'v checked the smaller hose and sucking air,so I thing is ok.
-
what kind carb cleaner??
This kind. :y
http://www.halfords.com/webapp/wcs/stores/servlet/product_storeId_10001_catalogId_10151_productId_202903_langId_-1_categoryId_165750
-
hi.maybe someone have tech2??before mark had,but I don't know how to find him.Or anyone to change my RPM....Please
-
hi.maybe someone have tech2??before mark had,but I don't know how to find him.Or anyone to change my RPM....Please
Changing the RPM with a Tech2 is not a solution to your problem. You need to establish what is causing it.
Have you checked for air leaks as Jimbob suggested?
-
yes I checked.Exhaust manifold can be problem??I can see someone repaired But maybe air come aut in gasket place.
-
engine
http://www.youtube.com/watch?v=iK9VINrftso
-
Dunno if it's my headphones, but that sounds horrible!
Not exactly purring is she. :o
If you take off the oil filler cap with engine idling, is there plenty of oil flicking around in the camcover?
-
As a starter, sounds like one of the pulleys driven by the aux belt is dry.
On top of that, also sounds like the exhaust manifold is blowing.
-
On top of that, also sounds like the exhaust manifold is blowing.
When I sprayed on cold running engine on exhaust manifold gasket then blowing.There can be problem??
Anyone have for sale??
-
hi,again.
Any idea??Today MOT