Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: ianboyo on 10 February 2011, 19:30:50

Title: torque settings
Post by: ianboyo on 10 February 2011, 19:30:50

hi is there a thread on the torque setting for all the engine componants for v6 can anyone help thank you
 :y

Title: Re: torque settings
Post by: PhilRich on 10 February 2011, 19:35:21

Quote

hi is there a thread on the torque setting for all the engine componants for v6 can anyone help thank you
 :y

Here you go mate  :y

http://www.omegaowners.com/forum/YaBB.pl?num=1156365122

Title: Re: torque settings
Post by: ianboyo on 10 February 2011, 19:46:08

thanks for the settings  :y

Title: Re: torque settings
Post by: PhilRich on 10 February 2011, 19:53:04

Quote

thanks for the settings  :y

I was only the 'Gopher', the Thanks go to Mr Marks DTM Calib who very kindly did the hard bit! :y

Title: Re: torque settings
Post by: Andy H on 10 February 2011, 21:23:54

Just curious

What do notes 1,2,3,4,5 & 6 say?

Is it something important..............?

Title: Re: torque settings
Post by: Entwood on 10 February 2011, 21:30:06

The notes are :

1) Use new bolts.
2) Insert bolts with bolt locking compound (red).
3) Use new nuts.
4) Clean thread and insert bolts with bolt locking compound (red).
5) Use new copper seal rings.
6) When re-using oxygen sensor, coat thread with special grease (black).
7) Tightening to 10 Nm is performed after 10 minutes for the old version (without additional bore) and only after assembly of the complete toothed belt drive for the newer version.
8) Clean thread of fastening bolts and insert with bolt locking compound (red).
9) Tightening to 20 Nm is only performed after installation of the lower alternator fastening bolt.
10) Before assembly, coat thread of screw-on port with assembly paste (white).
11) In three stages of 90° each.
12) Retightening not required




Perhaps these need adding to the post in the guide ??  or is my list in TIS different to the one Mark used ??

Title: Re: torque settings
Post by: Ploppy on 11 February 2011, 05:55:05

Just wondered if anyone had the torque settings for spark plugs, oil sump plug, oil filter , rear brake discs/ calipers and wheel bolts for the 3.2 V6?

Thanks

Ploppy :y :y