Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: henryd on 11 March 2011, 16:20:58

Title: V6 camshaft sprockets
Post by: henryd on 11 March 2011, 16:20:58
I have just picked up a set of 3.0 cams for my 2.5,are 3.0-2.5 sprockets all the same,I asume I use the original sprockets again,hopefully someone will confirm

thanks
Henry
Title: Re: V6 camshaft sprockets
Post by: Andy B on 11 March 2011, 16:24:49
Quote
I have just picked up a set of 3.0 cams for my 2.5,are 3.0-2.5 sprockets all the same,I asume I use the original sprockets again,hopefully someone will confirm

thanks
Henry

I'd assume both 2.5 & 3.0 cam pulleys are the same as each other, otherwise you'd need different cam belts for each engine.  ;)
Title: Re: V6 camshaft sprockets
Post by: Marks DTM Calib on 11 March 2011, 16:27:31
They are the same
Title: Re: V6 camshaft sprockets
Post by: henryd on 11 March 2011, 16:39:53
Thank you chaps,I have the 3.0 inlet divider on the way so almost time to commence battle :D :y
Title: Re: V6 camshaft sprockets
Post by: henryd on 12 March 2011, 16:16:56
started to strip it down today,thought I would check belt timing before pulling it off,glad I did,both banks about half a tooth out >:(.This is a gm kit fitted by a vauxhall tec 10000 miles ago just before I got the car,still,might explain why I have always thought it was a bit heavier on fuel than it should be :'(