Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: nordic on 20 May 2011, 16:57:09

Title: How do I remove Inlet Bridge & Injector Assembly?
Post by: nordic on 20 May 2011, 16:57:09

Hello,

My rocker cover gaskets are leaking so I have removed the Plenum as per the excellent guide.

Sadly, I have become a bit stuck on the next bit :-

'unplug the multiplug at the back that leads to the injectors, and undo the fuel line unions (17mm and 19mm). Then remove the 6 E12 torx bolts (3 per side) holding this on. Once all bolts are loosened (you'll need an extension bar) tease the inlet out. Get the right angle and it comes out with no force'

It is the part in red - the teasing it out that I cannot manage! Has anyone got any tips?

Cheers

Andy

Title: Re: How do I remove Inlet Bridge & Injector Assembly?
Post by: Entwood on 20 May 2011, 17:03:11

It's a tad tricky until you get it the first time . then its easy !  If you look on the left side of the "V" that it sits in .. there are 3 "indents" .. the 3 "sticky out" bits have to match those indents to lift it out. I find it best to keep the right hand side "low" then raise the left side to match those indents and it lifts straight out. 

As I said .. once you've done it a few times you'll know exactly how to do it !!!

Title: Re: How do I remove Inlet Bridge & Injector Assembly?
Post by: nordic on 20 May 2011, 18:04:45

FANTASTIC !!!!!!!!!!!

Thanks for your kind help - It's out!

You have saved me so much time - Cheers!!

 :y