Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: SteveT528 on 24 June 2011, 18:44:08

Title: v6 heads x30xe heads onto a 3.2 y32se?
Post by: SteveT528 on 24 June 2011, 18:44:08

Hi all, would 3.0 heads fit onto my y32se engine? im guessing their the same heads but different part numbers (3.0 heads had 4x different part numbers over the years anyway..

i have a set of new/recon 3.0 heads here that im going to port/polish which im going to run 4x g cams in. i hope they are the same if not it may rise compression from 10.1 to about 11.0 ish if they are different? would this be a bad thing if im keeping the engine N/A? Will the ecu handle a compression ratio so high?  Car is a 3.2 running 3.0 motronic 2.8 management. Any help from the tuners/guys that love modifying/playing with stuff would be great.

Title: Re: v6 heads x30xe heads onto a 3.2 y32se?
Post by: Marks DTM Calib on 24 June 2011, 20:27:28

Yes but, make sure they are the later type with the extra webbing between the spark plugs which has the drilled and tapped hole to secure the coil packs.

Title: Re: v6 heads x30xe heads onto a 3.2 y32se?
Post by: SteveT528 on 24 June 2011, 21:13:18

Thanks Mark, im running 3.0 management with plug leads so does that mean i can use any 3.0 heads?

any idea about the compression side of things? :y

Title: Re: v6 heads x30xe heads onto a 3.2 y32se?
Post by: 2woody on 26 June 2011, 08:49:03

Quote

any idea about the compression side of things? :y

just measure it ?

The general rule of thumb is that any engine mods will be incompatible with the current fuel map