Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: lou on 25 June 2011, 17:44:23
-
Just been out doing the usual checks. When I blip the throttle the back actuator does not move but the front is moving at a certain speed. Checked all connection and Vac and all seems normal. Should the back one change when reved? All seems ok when driving and have not notice any changes.
-
Mine is exactly the same - not sure if that's what it's supposed to do, as it may only activate "under load" rather than just a certain engine speed
-
yes, they will both moved when revved (at different times)
good hard blip to full power should do it :y
-
Need to be quite violent with the blipping to get the rear one to move ime.
Or get tech2 to test it remotely.
-
Perhaps I was too gentle with the throttle as i did not rev the guts out of it. I will give it a go......
-
hallo to all.
the multi ram valve on the back of inlet manifold should open on 4100rpm, while other one near radiator opens on 3500rpm.
i have a problem with that on the inlet manifold, it shows no signs of working. it shoud work on idle speed and on 4100rpm as i said. the valve is working when i take off The throttle position sesnor (TPS) and i turn it with my finger, then valve opens, but when i put it back on throttle body, valve is not working again.. could someone explain that strange situation? please help.