Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: geoff on 09 August 2011, 10:00:22

Title: dis module
Post by: geoff on 09 August 2011, 10:00:22

after loads and loads of rain,car started fine last night run alright then all of a sudden sound like running on 5 pots,looked this morning and there is no spark going to drivers side back plug nearest the back of the engine,could someone tell me if my dis moule is fewbared please,also display in car is flasing like mad but when you put lights on it stops :y :y :y

Title: Re: dis module
Post by: dbug on 09 August 2011, 22:27:20

Same as mine mate (apart from the rain), even same pot.
No flasing of display in car though
Have a look here - http://www.omegaowners.com/forum/YaBB.pl?num=1312124558

HTH

Title: Re: dis module
Post by: Alex W on 09 August 2011, 22:36:32

Mine was No.6. Passenger side backmost. Dis was knackered. Only £35 on Ebay and a couple of hours of pfaffing

Title: Re: dis module
Post by: geoff on 10 August 2011, 00:14:12

 :y :-?Thanks guys have ordered one off ebay did not think i would get one that cheap ,thanks again guys :y

Title: Re: dis module
Post by: geoff on 10 August 2011, 16:32:57

came today really quick, only ordered it yesterday,put on car job done runs miles better,but don't want to be doing one of them again in a hurry  ;D ;D ;D ;D,a pain in the arse to get at even with the intake removed and wiper scuttle panel lol ;D ;D ;D,thanks again guys :y :y :y :y

Title: Re: dis module
Post by: dbug on 10 August 2011, 16:56:12

Quote

came today really quick, only ordered it yesterday,put on car job done runs miles better,but don't want to be doing one of them again in a hurry  ;D ;D ;D ;D,a pain in the arse to get at even with the intake removed and wiper scuttle panel lol ;D ;D ;D,thanks again guys :y :y :y :y

Nice one  :y :y :y

Title: Re: dis module
Post by: geoff on 11 August 2011, 13:26:22

had look to day and water is dripping down on to it again have put rubber seal round metal plate to wiper panel does not leak as much only drips on to rocker cover now a little,can any body help as to fix this problem >:( >:( >:( :y :y :y

Title: Re: dis module
Post by: RobG on 11 August 2011, 13:42:37

The water comes through the joint between the 2 scuttle cover sections so check they are fitted correctly and interlocked correctly plus make sure that the smaller piece is sat correctly on the metal frame below it. Clear silicone sealant on the interlock will help.
If the foam/sponge attached to underside of scuttle is sodden it might be a good idea to remove scuttle completely and squeeze as much water as possible out

Title: Re: dis module
Post by: geoff on 11 August 2011, 21:34:58

cheers rob was joint of to pieces sorted leak on dis side got leak near wiper motor now this car is really pissing me off >:( >:( >:(