Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Bob G on 11 September 2011, 18:06:37
-
Exhaust is blowing seesm to be at the mesh type flexible joint (not had chance to crawl under yet) is there a simple fix or if I need to repalce parts how much of the exhaust needs it?
-
Flexi section can be bought seperately (ebay iirc) and I believe it then needs welding onto the original exhaust.
Im sure experienced 4 pot owners will be along shortly with more deatails. :y
-
Albs, that does make me feel a bit better, I assume you mean one of the one size fits all type that are on there? if so it is not going to be a drain on the national debt [smiley=2vrolijk_08.gif]
-
This one Bob
http://www.ebay.co.uk/itm/2-x-4-Exhaust-Flexi-Repair-Joint-100-x-50-Flexipipe-/320600194946?pt=UK_CarsParts_Vehicles_CarParts_SM&hash=item4aa542bf82
-
Many thanks Rob, was looking at them and there is a mass of them so your help invaluable, as for the other items under discussion, I will be underneath tommorow so will let you know. It could be :'( or :y
-
Many thanks Rob, was looking at them and there is a mass of them so your help invaluable, as for the other items under discussion, I will be underneath tommorow so will let you know. It could be :'( or :y
:y
-
that will fit, just make sure its welded back in the right place so it mounts back to the exhaust ok. :y
-
Buy the seperate flexi as suggested.
Its part of the cat section - do NOT be talked into replacing entire cat section, as pattern cats are useless and noisy