Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Ernie on 08 October 2007, 19:46:26
-
Hi all.Ive just helped remove a bose speaker set and amp from a Elite my friend is breaking.
As i helped remove it he offered it to me for a very good price. the thing is we removed all the speakers the amp and the loome is it just a case of removing all the standerd speakers and loome from my elite then plug all back in to the loome in the drivers side foot well.
Just wondered before i took it on tomorrow after work any advise would be grand.
With thanks
Chris.
:y
-
I forgot to mention that im running it of my Alpine head unit that is wired into the iso plug so should all be wired up fine.
-
The bose does not operate at the same levels as non amp'd systems.
-
I will be using the BOSE amp. if it aint to good he still has the blaupunk/bose headunit so may have to put first dibbs in on that then lol.
-
I will be using the BOSE amp. if it aint to good he still has the blaupunk/bose headunit so may have to put first dibbs in on that then lol.
Unless the Alpine has line level out, it won't work (though I seem to recall bose isn't quite line level out)
-
Cheers fella i will see how it goes tomorrow after work. the main bit i was after was does it just plug into the loome in the drivers footwell the same on my elite as it did on the 1 i took it out of.
Thanks for the help.
:y
-
from what I remember, bose head unit outputs at line level (0.7V) - most pre-outs on aftermarket head units run at 2 or 4V. So you'd need to wire up the pre-out to speaker connections as that's where the bose amp takes its' input from ...
-
yes mate it just plugs in the same and a fuse is needed toi be fitted in fusebox with a picture of a speaker under it bud !! but it wont work unless you use the bose head unit bud !! :y