Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Kait on 03 April 2009, 09:55:34
-
After replacing GID with CID and programming right code index, the Time/date automatic correction cannot be selected and is faded grey and no X mark in selction box. What is wrong :(?
It was working fine with GID and....I don't really remember, but I think it was working before rep. code index.
Car: 02 Omega 2.5DTi with Siemens NCDC 2015 and CID.
-
Do you have a GPS signal?
-
Do you have a GPS signal?
yes, GPS is working, i can read pos. long/lat in teh2, navigation display has my current position right.
-
How old is the software on the tech 2?
-
How old is the software on the tech 2?
hmmm..don't really know. I don't have any access to it at the moment.
It could be old tho.
-
When you do a code variant update it also downloads the firmware from T2...so if T2 has old code then it could donwgrade your firmware (in theory as I have not tried it)
-
When you do a code variant update it also downloads the firmware from T2...so if T2 has old code then it could donwgrade your firmware (in theory as I have not tried it)
And it would cause this prob?
I remember tech2 writting smt. like "code varian in tech2 is 2 and same as in cid" before rep. code index.
-
When you do a code variant update it also downloads the firmware from T2...so if T2 has old code then it could donwgrade your firmware (in theory as I have not tried it)
Yes, it can downgrade firmware done in Diagnostics section. It can't downgrade firmwares that are done via SPS
-
On the NCDx series, the clock is updated via GPS signal, hence a good GPS signal required.