Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Gpz John on 20 August 2010, 16:51:03
-
Hello All
I am fitting a new air con control panel , and I have to remove the radio to get to it
I was looking through the manual Re radio recode after removal and it says you need to turn radio off and press TP .
The problem I have is it wont turn off :-( .
Will this be a problem when i come to enter the code .
Thanks in advance
John
-
Hi
Forgot to add its a CDR 2005 model
-
The problem I have is it wont turn off :-( .
Will this be a problem when i come to enter the code .
John
Very likely to cause you a problem
:'(
-
Thanks Dave
Not really the anwser I needed :( :(
-
You could try holding the buttons down whilst turning the ignition on/off - may allow you to fool it into a code entry screen -
only one way to find out !!
-
you could take out/put back the fuse and maybe fooling it into thinking its switched off ...... or your actual on/off button is loose.. usually held in by two nuts. try tightening them down thus pulling the switch forward