Omega Owners Forum
Omega Help Area => Omega Electrical and Audio Help => Topic started by: Mr Gav on 22 April 2011, 11:49:28
-
I`ve got the warning `vision fld/low beam` on my MFD, is there any way to tell if it`s the sensor or adjusters that have failed.
When I park on my drive on a night, it`s on a slight incline, the headlamps go up and down like they can`t make their minds up where to rest and I`ve also had someone flash at me as though I`ve got full beam on.
TIA :)
-
Visually check the sensors, esp front. If both lights are going mental together, that points more to sensor than servos :y
-
Had the same twice on two of the elite's I've had and on both it was the front sensor like TB said :y
-
Visually check the sensors, esp front. If both lights are going mental together, that points more to sensor than servos :y
Yeah both lights go mental together, it`s quite funny watching them sometimes.
Next question: Is there just the sensor on the N/S wishbone or are there some more for each headlight?
-
Front wishbone and rear N/S trailing arm
-
whta i have noticed is that when this message comes up i have to change the wishbone bushes :). the wishbones plays in other directions that it is suposed to
-
whta i have noticed is that when this message comes up i have to change the wishbone bushes :). the wishbones plays in other directions that it is suposed to
Good point, When I changed the wheel bearing I noticed the the vertical bush had started splitting so I`m gonna do both of these anyway so I`ll not start swapping sensors until I`ve done them.
-
whta i have noticed is that when this message comes up i have to change the wishbone bushes :). the wishbones plays in other directions that it is suposed to
The sensors are linked by ball joints so can't see worn wishbone bushed affecting them
-
mine pop out when the bushes are worn.. its my wear sensor :P.. they are designed to work up or down not sideways, besides mine pop out from the sensor itself not from the ball joints :)