Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: downsmen on 18 November 2011, 18:54:41
-
Hi after replacing the oil cooler due to a leak, the car does not run smoothly anymore. :'(
when you start it up it runs between 600 to 1500 rpm and keeps like this even whist driving almost like the throttle is sticking.
Any Ideas
Many Thanks
-
Possible vac leak. Doublecheck all your work
-
is there a diagram or picture of where all the vacum pipes go etc? :y
-
Have you re-assemble the throttle cable correctly? Assuming you have the 2.5 or the 3.0 :-\
-
i think i did
not sure now!!!!!
-
is there a diagram or picture of where all the vacum pipes go etc? :y
http://www.omegaowners.com/forum/index.php?topic=90499.0
-
With the engine running, spray around the vac pipes/plenum LIGHTLY with carb cleaner, if the engine note changes the carb cleaner has been sucked in and burned as unmetered fuel ... you have just found the vac leak !!
Rectify, check again, once happy wipe down with paper towel.
Result : fixed vac leaks and a nice clean engine :)
-
Thanks :y
i shall try that in the morning
-
Thanks guys for your advice :y
i found a split hose on the back of the plenum, new one fitted and all fine again now.
Thanks again :y :y
-
Thanks guys for your advice :y
i found a split hose on the back of the plenum, new one fitted and all fine again now.
Thanks again :y :y
Result!! :y :y