Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: abdin on 27 December 2011, 07:04:35
-
Hello..every one
I'm facing a problem with my omega 2.2 /2002 which started a couple of weeks ago .
first the EML light(car with spanner) went on and transmission went in to limp mode ...hard to change gears.
when scanned with OBD-II scanner I got p0340,p1700 and p1781 codes. I checked the wires,cables and haness connections but seems ok,so I replaced the CAM sensor with brand new VX genuine one ,cleared both engine and transmission codes and i'm still getting the same error codes and EML light still on and engine hesitate when reaching 4500 rev. appreciate your help ..Thank you
-
Still seeing cam sensor fault. Faulty sensor? Is it worth tracing the wiring back the ecu for faults/damage?
Ignore other codes until 0340 is resolved.
-
Thank you Chrisgixer..for your reply ..now i'm getting p1781 code only ..with eml light still ON ..next step will be transmission selector & harness and will follow wiring to TCM ..(((by the way where the TCM is located ?!))) hope this will put an end to this suffering...once again thank you ..merry xmas ..and happy new year to all of you
-
Are you getting that code from Engine or TCM?
CAN Receives errors are invariably caused by other stored codes in the Engine, TCM or ABS. Clear all codes in these 3, and see what comes back