Omega Owners Forum
Omega Help Area => Omega General Help => Topic started by: Latchie_3.0v6 on 28 January 2012, 19:05:23
-
Ok so heat wasn't best in car so decided to flush out heater matrix but as boys said on here about the two pipes being hot. Only top pipe was hot bottom pipe was warm same as before flush.
Wot else could possibly be wrong with it and just wondering if I flushed it right.
Went by guide on here
Used two hose pipes
Ran water until it ran clear
Then reversed pipes and flushed other way
Then fitted hoses back on to car again
Started car
Kept cap of Coolent bottle
Ran until warm but nothin seemed to happen as lads said about burping
Then took car for a good run but was still the same and coolant level hasn't dropped
Any ideas
I'm thinking blocked pipes possibly
-
might be a silly question but did you run it with heater on full wack :-\
-
might be a silly question but did you run it with heater on full wack :-\
Yeah set at hi and fan at full wack.
Going to do it tomorrow again but turn water from hose on a bit stronger and a bit longer.
-
might be a silly question but did you run it with heater on full wack :-\
Yeah set at hi and fan at full wack.
Going to do it tomorrow again but turn water from hose on a bit stronger and a bit longer.
sorry to state the obvious ::)
-
might be a silly question but did you run it with heater on full wack :-\
Yeah set at hi and fan at full wack.
Going to do it tomorrow again but turn water from hose on a bit stronger and a bit longer.
Although my Dad ended up replacing the heater matrix on his Granada he had limited success by leaving a dissolved dish washer tablet in his matrix over a few days - left both hoses in place on the matrix & poured the mix in with a jug. Might be worth a try ........ :-\ :-\ :-\
-
Ok so heat wasn't best in car so decided to flush out heater matrix but as boys said on here about the two pipes being hot. Only top pipe was hot bottom pipe was warm same as before flush.
Wot else could possibly be wrong with it and just wondering if I flushed it right.
Went by guide on here
Used two hose pipes
Ran water until it ran clear
Then reversed pipes and flushed other way
Then fitted hoses back on to car again
Started car
Kept cap of Coolent bottle
Ran until warm but nothin seemed to happen as lads said about burping
Then took car for a good run but was still the same and coolant level hasn't dropped
Any ideas
I'm thinking blocked pipes possibly
Did you get the hoses off the matrix easily enough?
-
Ok so heat wasn't best in car so decided to flush out heater matrix but as boys said on here about the two pipes being hot. Only top pipe was hot bottom pipe was warm same as before flush.
Wot else could possibly be wrong with it and just wondering if I flushed it right.
Went by guide on here
Used two hose pipes
Ran water until it ran clear
Then reversed pipes and flushed other way
Then fitted hoses back on to car again
Started car
Kept cap of Coolent bottle
Ran until warm but nothin seemed to happen as lads said about burping
Then took car for a good run but was still the same and coolant level hasn't dropped
Any ideas
I'm thinking blocked pipes possibly
Did you get the hoses off the matrix easily enough?
Yeah bit of a tight space but handy enough.