Omega Owners Forum

Omega Help Area => Omega General Help => Topic started by: dcjg70 on 01 February 2012, 13:52:08

Title: Replacement Battery
Post by: dcjg70 on 01 February 2012, 13:52:08
Hi all,

I am going to endeavour to change the battery on the car tonight which has by the looks of it been on it since new. I have had a look through the maintenance guides but can't seem to see an answer to my question. Quite a simple one really.

What is the best/correct way to remove the battery and how do I remove the fuse pack that sits above the battery so I can get to the positive terminal?

Cheers,

Dan.
Title: Re: Replacement Battery
Post by: fiend61 on 01 February 2012, 14:29:52
firstly undo negative terminal but dont take off or power sounder will go off  ::) go to car and switch on ignition turn off then you have 15secs to take off the negative terminal and power sounder will not go off  :y  the fuse carrier above positive terminal is held on to the larger fuse carrier by 2 x plastic clips look inbetween them and you will see press the clips and remove upwards, more than likely it will come off if you just pull upwards  :y
lastly have you your radio code? because it will kill radio and you have to input the code (unless code disabled or ncdc)  the windows/sunroof will all have to reset aswell look at the guides and it will tell you how in there  :y

hope this helps  :y
Title: Re: Replacement Battery
Post by: zirk on 01 February 2012, 14:39:05
Plus 13mm Socket with long extension to undo the Battery Holder Clamp, which if its been in place since day 1 will probably snap the bolt, so either redrill and Tap or drill another hole about 15mm away from it and use Stainless Steel Nut and bolt to refit.

Chris. 
Title: Re: Replacement Battery
Post by: fiend61 on 01 February 2012, 15:11:42
Quote
Plus 13mm Socket with long extension to undo the Battery Holder Clamp

never had one in any of mine zirk  :y
Title: Re: Replacement Battery
Post by: Andy B on 01 February 2012, 15:18:54
Quote
Plus 13mm Socket with long extension to undo the Battery Holder Clamp

never had one in any of mine zirk  :y

Should have had  ;) ;)
Title: Re: Replacement Battery
Post by: Andy B on 01 February 2012, 15:20:33
...... and how do I remove the fuse pack that sits above the battery so I can get to the positive terminal?

Cheers,

Dan.

Poke your key in the gap between the fuse carrier bit & the triangular main fuse/relay box & the two should easily separate.  :y :y
Title: Re: Replacement Battery
Post by: fiend61 on 01 February 2012, 15:23:41
i know andy but none of mine have ever had one  :o  except the last one which i put on myself after trying to lift a battery out of a breaker and nearly giving myself a bloody hernia  ::) it was only after much swearing ,huffing,puffing and swearing did i notice the clamp  :-[
Title: Re: Replacement Battery
Post by: Andy B on 01 February 2012, 15:28:25
i know andy but none of mine have ever had one  :o  except the last one which i put on myself after trying to lift a battery out of a breaker and nearly giving myself a bloody hernia  ::) it was only after much swearing ,huffing,puffing and swearing did i notice the clamp  :-[

It does remond me that mine needs fitting properly. I think the clamp/plate in on upside down cs I noticed that it doesn't actually clamp the battery before the bolt tightens  :-\
Title: Re: Replacement Battery
Post by: fiend61 on 01 February 2012, 15:36:56
Quote
suǝʇɥƃıʇ ʇloq ǝɥʇ ǝɹoɟǝq ʎɹǝʇʇɐq ǝɥʇ dɯɐlɔ ʎllɐnʇɔɐ ʇ,usǝop ʇı ʇɐɥʇ pǝɔıʇou ı sɔ uʍop ǝpısdn uo uı ǝʇɐld/dɯɐlɔ ǝɥʇ ʞuıɥʇ ı ˙ʎlɹǝdoɹd ƃuıʇʇıɟ spǝǝu ǝuıɯ ʇɐɥʇ ǝɯ puoɯǝɹ sǝop ʇı

there you go andy sorted  :y
Title: Re: Replacement Battery
Post by: Andy B on 01 February 2012, 17:00:51
Quote
suǝʇɥƃıʇ ʇloq ǝɥʇ ǝɹoɟǝq ʎɹǝʇʇɐq ǝɥʇ dɯɐlɔ ʎllɐnʇɔɐ ʇ,usǝop ʇı ʇɐɥʇ pǝɔıʇou ı sɔ uʍop ǝpısdn uo uı ǝʇɐld/dɯɐlɔ ǝɥʇ ʞuıɥʇ ı ˙ʎlɹǝdoɹd ƃuıʇʇıɟ spǝǝu ǝuıɯ ʇɐɥʇ ǝɯ puoɯǝɹ sǝop ʇı

there you go andy sorted  :y

Not that way round .........  >:( >:(

I meant the plate needs turning over   ;D ;D
Title: Re: Replacement Battery
Post by: zirk on 01 February 2012, 17:46:08
Will fail an MOT without the Clamp, as from Jan 2012.

Quote:

3) Car Battery Security

The battery will be checked for security. This should present few problems unless the wrong sized battery is fitted, the clamp is loose or corrosion has affected support or security of the battery.

 ;) ;)
Title: Re: Replacement Battery
Post by: robson on 01 February 2012, 17:48:55
Yes my clamp bolt sheared off now got a nut and bolt
Title: Re: Replacement Battery
Post by: GastronomicKleptomaniac on 01 February 2012, 17:54:15
Will fail an MOT without the Clamp, as from Jan 2012.


Has always been an item checked at the roadside under the Ways & Means Act ;)
Title: Re: Replacement Battery
Post by: hotel21 on 01 February 2012, 18:54:51
Will fail an MOT without the Clamp, as from Jan 2012.


Has always been an item checked at the roadside under the Ways & Means Act ;)

Guessing you perhaps means RV(C&U) Regs?   ;D

Certainly always was a fail and an immediate PG9 prohibition (not a simple 21 day fix and examine at test station), particularly if the driver failed the Mk1 Attitude Test interpretation schedule....   :)
Title: Re: Replacement Battery
Post by: dcjg70 on 01 February 2012, 20:48:31
Thanks folks, I have a new battery will try fitting it tomorrow night...  :y
Title: Re: Replacement Battery
Post by: GastronomicKleptomaniac on 01 February 2012, 21:32:39
Will fail an MOT without the Clamp, as from Jan 2012.


Has always been an item checked at the roadside under the Ways & Means Act ;)

Guessing you perhaps means RV(C&U) Regs?   ;D


;D
Title: Re: Replacement Battery
Post by: Webby the Bear on 01 February 2012, 21:40:30
Thanks folks, I have a new battery will try fitting it tomorrow night...  :y

Will be dead easy mate.

That small fuse box.... just open it, push on the middle plastic piece and pop fuse box up at same time. Easy  :)