Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Re: heater not working

« on: 05 December 2011, 14:13:33 »

Think I have worked it out.
It's either the heater matrix blocked or the valve that lets the hot water flow into the matrix thats not working.
I realised  this morning (drove 26miles in the cold) that the blower does not start working until the heater has got warm.
When I stopped I checked the heater pipes and they were cold. I'am going to change the valve first as I think it is more likely that as the heater stopped working suddenly. I think if it was the matrix blocked it would have gradualy got cooler. Famous last words!!

2

Omega Electrical and Audio Help / Re: heater not working

« on: 04 December 2011, 22:06:50 »

Yes the outside temperature works fine

3

Omega Electrical and Audio Help / Re: heater not working

« on: 04 December 2011, 16:18:18 »

No I believe the fan is okay When I use the dimister I can ajust the fan speed okay
Will have a look to see if the scuttle drain is blocked
Thanks

4

Omega Electrical and Audio Help / Re: heater not working

« on: 04 December 2011, 15:27:48 »

Thanks
but that did not work

5

Omega Electrical and Audio Help / heater not working

« on: 04 December 2011, 12:20:19 »

hi
I'm new on this site I have owned my Omega from new and do most of the repair on it myself.
My climate control has started running cold.
Once the engine has warmed up the fan does not appear to work unless I turn it to either high or low. Where ever it is it does not get hot.
When turning the auto switch on or off you can hear a noise I assume it a selenod opening & closing
If the demiser is turn on the fan works but again no hot air.
Any help would be much appreciated
Thanks
Fred