Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Shandyman

Pages: [1] 2
1
Newbie Welcome Area / Re: Engine using a gallon of oil a week
« on: 14 September 2013, 16:08:44 »
Valve stem oil were changed on head rebuild and it weren't smoking before.Anyone had problems with engine breather/oil separator?😫

2
Newbie Welcome Area / Engine using a gallon of oil a week
« on: 11 September 2013, 23:05:57 »
Recently rebuilt top end due to cambelt failure and after fixing other issues it now going through a gallon of oil a week.No leaks.Engine fine when cold but when it gets to 80c exhaust smokes badly mainly after overrun phase and is embarrassing when setting off,any ideas guys?

3
Omega General Help / Re: emergency throttle response
« on: 29 August 2013, 22:43:09 »
F**k if I'd known Andy B was in Bury would of brought car down!!!!😕😕

4
Omega General Help / Re: emergency throttle response
« on: 27 August 2013, 17:55:45 »
Finally got to the problem......cos I changed the cam sensor and got an aftermarket one it turns out it interferes with the engine ECU and puts throttle in emergency mode and won't adapt....Fitted original GM sensor cleared faults and now ok. 😀😀😀👍

5
Omega General Help / Re: emergency throttle response
« on: 16 August 2013, 18:03:05 »
Codes I have got areP0120,0700,1700,1120 ,1122 and 1550.I have got 5vts at pin B55 and 0 vts at pin B39 checked wires from ECU to pedal sensor and they are ok ??? :😫😫

6
Omega General Help / emergency throttle response
« on: 15 August 2013, 21:56:55 »
Hi,I have changed cam sensor,throttle housing,throttle pedal sensor and engine ECU.Engine starts and runs normally but poor throttle response and spanner light wont clear.The warmer the engine gets the worse it gets until it wont restart.fault codes are APP throttle sensor,TP throttle sensor and throttle adaption.I can operate the throttle housing with diag machine and that works but when you read throttle pedal sensor the max position is only 67%.I have had to rebuild the cyl head after one of the rollers gave up and took everything with it and I've checked engine loom to see if i've trapped a wire but all looks fine.............ps after running for 10 mins start getting EGR faults and the exhaust fumes stink,any ideas please

7
Faults I have are throttle position sensor and adaption faults.engine starts and runs fine but won't rev....!after 15-20 mins cuts out....cannot get throttle actuator to operate At all even though it has been changed

8
Ok .,roller disintegratred took belt out, valves and guides ...all have been replaced.the problem I've got is that it that it starts but cannot clear or reset throttle adaptionsp

9
looked on Op COM and i cant get it to work
have also tried bosch KTS,  snap on solus plus and VCDS.......nowt works

10
Omega General Help / Re: Spoiler
« on: 27 March 2012, 18:37:14 »
Yeah 2001 CDX auto saloon

11
Omega General Help / Re: Engine light on after 60 miles
« on: 27 March 2012, 18:34:32 »
Cos the Maf was reading wrong it was running on weaker mixture than normal which overheats the cat, fault code says cat conv threshold not reached(basically cat efficiently) Still runs ok but light on

12
Omega General Help / Spoiler
« on: 26 March 2012, 23:04:34 »
Hi guys I'm after an original boot spoiler if any ones got one

13
Omega General Help / Re: Engine light on after 60 miles
« on: 26 March 2012, 23:02:52 »
Hi Johnnycool, found one on ebay but I'm sure if you search the various auction sites you will find one.........ps. Due to the time it took me to fix the faulty MAF it's now burnt the cat out(😡😡😡😡😡😡,)

14
Omega General Help / Re: Engine light on after 60 miles
« on: 14 March 2012, 18:16:02 »
Fit a used MAF and have done over 100 miles
miles since with no engine light on.An added bonus is that I'm now getting an extra 6mpg more!!!!!

15
Omega General Help / Re: Clonking steering still .
« on: 08 March 2012, 22:05:37 »
Yet checking the steering idler arm cos I've changed mine twice in a year and if it does again it's having a genuine vauxhall one fitted

Pages: [1] 2

Page created in 0.008 seconds with 13 queries.