Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Newbie Welcome Area / Hello all new from the USA!

« on: 06 May 2012, 23:18:23 »

Well I just picked up a 2.0 Omega auto. Don't know too much about them except that it has the first four banger called the ECOtec and that it is a GM V-body that my Pontiac GTO is based off of. I'm wanting to go thru and change all the fluids. I also want to do some rust proofing. There is some rust thru-out but it is not too bad, nothing I can't take care of with a little time.

2

Omega General Help / Re: New owner made a mistake

« on: 06 May 2012, 09:27:07 »

Thanks for the help!

3

Omega General Help / New owner made a mistake

« on: 06 May 2012, 08:45:31 »

Hello. I'm a new owner of a Omega 2.0 16V. I made the mistake of washing my engine bay with the battery connected after performing a oil and spark plug change. I fired the car up now I got a check engine light. I jumpered the ECU and now I got a P0500 and P0340. Is it possable I messed up the ECU? The car seems to run fine until I try to accelerate past 40mph and it just hits the rev limit. Any advice?