1
Omega General Help / 2.0 auto to 3.0 manual conversion
« on: 24 June 2014, 23:26:04 »
Hi i am looking at converting a 2 litre auto to a 3.0 manual but i don't know whats involved i have a complete donor car
- 06 September 2025, 16:39:58
- Welcome, Guest
News:
Please play nicely. No one wants to listen/read a keyboard warriors rants....
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Omega General Help / Re: supercharged miggy
« on: 06 April 2014, 22:00:34 »
maybe not worth the bother but what about going down route of a v8 conversion
3
Omega General Help / supercharged miggy
« on: 06 April 2014, 20:33:16 »
looking to supercharge my 3.0 but don't know where to start ie what charge to use
4
Omega General Help / Re: ENGINE PAINT
« on: 15 January 2014, 21:54:48 »
car its self is black was thinking red for inlet black for plenum and not sure for the heads
5
Omega General Help / ENGINE PAINT
« on: 15 January 2014, 18:23:11 »
i'm needing some advice , i want to paint the heads on omega and the inlet manifold aswell but can't decide what colour would be best any ideas 
6
Omega General Help / break or bust
« on: 29 December 2013, 18:10:28 »
time to start getting heads off AGAIN due to bent valves just cba but will be worth it in the end
7
Omega General Help / Re: turning over not starting
« on: 24 October 2013, 21:14:01 »
looks like it the timing slipped mayhave bent valves 
8
Omega General Help / Re: turning over not starting
« on: 22 October 2013, 21:11:55 »
new leeds new sparks and there is power to spark plugs will be checking all tomorrow
9
Omega General Help / Re: turning over not starting
« on: 22 October 2013, 20:41:02 »
there is a little oil in lifters but if theres not enough would that stop it starting
10
Omega General Help / Re: turning over not starting
« on: 22 October 2013, 20:13:38 »
aye oil it hydraulic lifters there is fuel getting pump as we crack the fuel line off the turned engine over and fuel came out
11
Omega General Help / Re: turning over not starting
« on: 22 October 2013, 19:34:26 »
no codes stored when i put leeds in i went by numbers on coil pack can't remember them now , i have just heads done so if there is little oil where lifters are would that stop it starting ?
12
Omega General Help / turning over not starting
« on: 22 October 2013, 19:16:24 »
car keeps turning over and not starting so put new crank sensor on but still no joy is there anyway that numbers on coil pack are wrong ? we put leeds in order as follows from front nearest timing belt driver side 135 and passenger side 246
13
Omega General Help / Re: won't start x30xe omega
« on: 20 October 2013, 22:27:25 »
must be later one i have as they coming straight up , so if numbers on pack not the same as pic will i do it as per the pic instead
14
Omega General Help / Re: won't start x30xe omega
« on: 20 October 2013, 22:17:27 »
well we went by numbers on the coil pack can't remember if its same as later one as i have a 98 3.0
15
Omega General Help / Re: crank sensor??
« on: 20 October 2013, 20:59:25 »
spot on i hope new sensor starts