Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: Bad running (Electrical or Mechanical)

« on: 08 December 2012, 18:05:29 »

On my old might I had similar problems, ran rough especially when accelerating. Again I could power through it.
Took to local garage. They couldn't find a fault, no codes. turned out to be the dispack. When they took it off it was cracked, causing the poor running

2

Omega General Help / Re: cambelt problems

« on: 11 November 2012, 18:34:51 »

Stopped for tonight. Got cams in correct place and locked. Will try again with belt tomorrow.
Will wait and see if I have indeed bent anything 

3

Omega General Help / Re: cambelt problems

« on: 10 November 2012, 20:34:31 »

Thanks that seems to ring a bell somewhere

4

Omega General Help / Re: cambelt problems

« on: 10 November 2012, 18:35:19 »

I used the cam lock kit! Using DVD from this site.
Left hand bank is or was slightly advanced so the lock would not fit. Trying to retard left bank, but ended up advancing it more.

Might well be something simple

5

Omega General Help / cambelt problems

« on: 10 November 2012, 16:13:46 »

 so decided to do my Cambelt today What a nightmare, struggled to strip everything down just to get to the belt!
Finally now got to it. Got everything to TDC. Put right hand lock in place. However bank 1 and 2 were slightly advanced. Have tried to adjust back, using the centre tensioner, but now it has become even further advanced, and I am unable to get it back where it should be 
What have I done? How do I retard it back to where out should be??
It's 2000 Elite, x30e.