1
Omega General Help / Re: Front Shock Problem
« on: 07 January 2008, 23:14:35 »
Drop links connect from the anti-roll bar to the shock ? If so they were replaced and the knocking was still there.
Andy
Andy
- 27 July 2025, 20:33:07
- Welcome, Guest
News:
Search the maintenance guides for answers to 99.999% of Omega questions
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Front Shock Problem
« on: 07 January 2008, 21:12:55 »
Hi all
Can anyone help please, on my mega the round plates on the front shocks that secure the top of the shock are sitting 12mm above the wing and I get a knocking sound. The wishbones were changed a few weeks ago for the MOT control arms are also renewed. I was wondering if this was wear on the top bush but 12mm seems a little too much so I thought I'd check with you guys first.
Thanks in advance
Andy
Can anyone help please, on my mega the round plates on the front shocks that secure the top of the shock are sitting 12mm above the wing and I get a knocking sound. The wishbones were changed a few weeks ago for the MOT control arms are also renewed. I was wondering if this was wear on the top bush but 12mm seems a little too much so I thought I'd check with you guys first.
Thanks in advance
Andy
3
Omega General Help / Re: Omega Will Not Start
« on: 15 September 2007, 15:52:04 »
Cheers Markjay for speedy reply and pic, is there any way testing it with a multimeter ?
Regards Andy
Regards Andy
4
Omega General Help / Omega Will Not Start
« on: 15 September 2007, 15:06:23 »
Hi All
Can anyone help me with this please my Omega will not start having no spark and no fuel, I have done paperclip test and it lists the following
CODE 145 Incorrect immobiliser signal recieved
CODE 19 RPM signal (crankshaft sensor)
CODE 135 'check engine' lamp (fault code lamp)
Recently it would not rev above 4500 RPM (as though the rev limit had been reduced ) and on close inspection I found the sparkplug wells full of oil, and with the help of some of the brilliant posts on this site I fitted some Veccy covers and new leads. On the test drive it ran very smoothly but when warm the 44500 RPM problem returned, running very low on fuel I reversed up an incline and the engine cut out it then started again, put car away and it cut out again and hasen't started since.
Other info
Omega MV6 1995 3.0XE No factory immobiliser fitted (ex Police demonstator ).
Many thanks in advance
Andy
Can anyone help me with this please my Omega will not start having no spark and no fuel, I have done paperclip test and it lists the following
CODE 145 Incorrect immobiliser signal recieved
CODE 19 RPM signal (crankshaft sensor)
CODE 135 'check engine' lamp (fault code lamp)
Recently it would not rev above 4500 RPM (as though the rev limit had been reduced ) and on close inspection I found the sparkplug wells full of oil, and with the help of some of the brilliant posts on this site I fitted some Veccy covers and new leads. On the test drive it ran very smoothly but when warm the 44500 RPM problem returned, running very low on fuel I reversed up an incline and the engine cut out it then started again, put car away and it cut out again and hasen't started since.
Other info
Omega MV6 1995 3.0XE No factory immobiliser fitted (ex Police demonstator ).
Many thanks in advance
Andy
Pages: [1]