Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: vauxhall omega estate crankshaft pulley replacement

« on: 10 January 2014, 11:24:34 »

Hi guys well its done . Plus gas didnt reach thread of bolt but did lubricate pulley on end of crankshaft so that once bolt was undone pulley separated easily. New pulley fitted and engine running o.k thankyou all for advice and assistance.

2

Omega General Help / Re: vauxhall omega estate crankshaft pulley replacement

« on: 04 January 2014, 11:14:33 »

Hi guys thanks for the input . I have ordered replacement item and will advise on outcome later

3

Omega General Help / Re: vauxhall omega estate crankshaft pulley replacement

« on: 02 January 2014, 22:31:11 »

Hi thanks for response. I cannot find any other bolts at all . The engine is a 2.2 dti ecotec It sure looks that only one bolt secures

4

Omega General Help / Re: vauxhall omega estate crankshaft pulley replacement

« on: 02 January 2014, 21:43:38 »

hi thanks for replies and no I didnt overheat it I was watching temp guage all the way. However the pulley is made up of two rings with a rubber "damper" in between rubber has degraded and sheared leaving me with outer ring and inner ring no longer connected. Pulley is fixed to cam shaft with 1 large central bolt which is torqued to 150nm plus any ideas on how to remove it

5

Omega General Help / vauxhall omega estate crankshaft pulley replacement

« on: 02 January 2014, 21:11:39 »

Having managed to get home with no power steering and no charge or water pump I discovered that the fanbelt had not broken but the crankshaft pulley had disintegrated into two parts . How do I remove the old one and replace it?