1
Omega Electrical and Audio Help / ccr800
« on: 06 July 2009, 21:04:36 »
hi all can anyone give advise on fitting a ccr800 bose system in my facelift as ime unsure if this will just fit into place without to much messing thanx darren
- 07 September 2025, 22:21:44
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Omega Electrical and Audio Help / Re: omega main light switch
« on: 11 December 2008, 21:35:13 »
just like to say thanx everyone for your help and ideas and ive now been given a light switch of a 98 model . the only difference being this one has only one fog light switch the other being blank but ive fixed that problem by taking out the curciut board of my old unit and putting it in my new unit also replacing blank fog switch with the double fit one and now workin perfectly thanx again .........
3
Omega Electrical and Audio Help / Re: omega main light switch
« on: 26 November 2008, 19:30:32 »
cheers mark pm sent
4
Omega Electrical and Audio Help / omega main light switch
« on: 25 November 2008, 00:10:01 »
hi all can anyone answer my question my light switch has decided to pack up and the only one i can get hold of short notice is one from a prefacelift model will this fit my 2002 model any ideas please
5
Omega Electrical and Audio Help / Re: head unit
« on: 05 November 2008, 19:33:39 »
thanx for that the boy .as ime not sure witch unit ime getting yet going to scrapers tommoro to have a look wich model it is all i know is it is out of a elite and its a phillips make
6
Omega Electrical and Audio Help / head unit
« on: 05 November 2008, 19:17:09 »
hi can anyone advise on changing head unit from a cdr 2005 to either a ccrt 2006/2008 or a cd 30 unit will these other units be plug and play or not any ideas thanx 
7
Omega Electrical and Audio Help / bulb replacement facelift
« on: 18 September 2008, 21:25:30 »
hi just a quick question about bulb replacement on 2002 omega is this easy to do as mine have gone out on centre console and would like to replace these if easy enough to do
9
Omega Electrical and Audio Help / window switchs
« on: 08 October 2007, 16:58:28 »
hi all just a quick question on the window switchs do you have to desolder them to get them out or is there a plug for them hiding some where center console and rear door ones
10
Omega General Help / code p1870
« on: 18 March 2009, 16:52:54 »
hi all ive just connected my gs500 maxscan tool and code p1870 has appeared [ Transmission Component Slipping ] as i havent a clue as to what this could be can anyone point me in the right direction or give an idea as to the problem part please
11
Omega General Help / Re: fault code any help please
« on: 14 February 2009, 17:03:44 »
thanx will ask the question now
12
Omega General Help / Re: fault code any help please
« on: 14 February 2009, 16:58:53 »
thanx the boy so two of the codes not valid and the c0300 code random misfire well still no clue as to my loss of power then but could still be cam sensor maybe or ?
13
Omega General Help / Re: fault code any help please
« on: 14 February 2009, 16:47:07 »
engine size 2.2 2002 auto
14
Omega General Help / fault code any help please
« on: 14 February 2009, 16:43:26 »
hi all just an add on to my recent post [loss of acceleration] ive had a visit from the rac man and a diagnostic was done and came up fault codes c0300 co718 c3000 allso a long term fuel of -99% sensor fault ? any ideas please
15
Omega General Help / Re: loss of acceleration
« on: 13 February 2009, 20:44:22 »
sorry no fault code but i have a 2002 2.2