1
Omega General Help / Re: warm Engine missfire / stall
« on: 06 September 2016, 18:45:21 »
Thanks all will get checking....
- 21 July 2025, 23:13:29
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Re: warm Engine missfire / stall
« on: 03 September 2016, 15:17:14 »
Yes looked at pedal trick but showing crank sensor that I have been told is almost a "stanbdard response" and does not really explain the temp issues.
I was wondering about MAF / Throttle sensor
I was wondering about MAF / Throttle sensor
3
Omega General Help / warm Engine missfire / stall
« on: 01 September 2016, 13:29:47 »
Hi. Have a 2.6 V6 auto 03 plate.
Runs perfectly when cold, kickdown full power etc, But when warm ish / restart after short run misfire and stalls restarts in "safe mode" max 4000 revs. Then eventually gets properly warmed up and goes back to running ok on full power. What causes temp sensitive? Any sensors checking temp and throttle? Been running on V-Power petrol for weeks.
Thanks
Runs perfectly when cold, kickdown full power etc, But when warm ish / restart after short run misfire and stalls restarts in "safe mode" max 4000 revs. Then eventually gets properly warmed up and goes back to running ok on full power. What causes temp sensitive? Any sensors checking temp and throttle? Been running on V-Power petrol for weeks.
Thanks
4
Omega General Help / Re: V6 2.6 Engine Errors lights
« on: 22 June 2016, 18:14:47 »
Many thanks
I've had to leave it a day or two but back now chasing issues...
Would this also explain why the engine cuts out after say 7 miles, temp up to 80 ish on the gauge, than restarts with lots of right foot and runs ok if the temp stays above 85 ish.
Got a 0100 error when "pedal checked"....
Got local garage to fit new crank sensor - so Should/better had be OK....
Its a great car when it goes well so am persevering!
I've had to leave it a day or two but back now chasing issues...
Would this also explain why the engine cuts out after say 7 miles, temp up to 80 ish on the gauge, than restarts with lots of right foot and runs ok if the temp stays above 85 ish.
Got a 0100 error when "pedal checked"....
Got local garage to fit new crank sensor - so Should/better had be OK....
Its a great car when it goes well so am persevering!
5
Omega General Help / V6 2.6 Engine Errors lights
« on: 16 June 2016, 19:26:06 »
Hi and help. Have a 03 reg 2.6 V6 auto. Can anyone guide me to a reliable wiring diagram? I have problem with engine management and emission lights coming on (spanner and engine) and then going away sometimes. Currently emission light on most of the time. Months ago had new cambelt and new coils. When this lights problem first happened got a new crank sensor.. could that be "Wrong?". Any help with wiring diagram or ideas of what to look at .. Pedal trick gives 0420, 0430 and 0340, 0330 ................S Buffo P.S. occasionally get the low beam check error message coming on
Pages: [1]