Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Jim 3.2

Pages: [1]
1
Omega General Help / Re: Going off 1/3and 5 cylinders
« on: 27 July 2018, 11:37:53 »
Thanks everyone for replying i tried swapping the Ecu made no difference the lamba sensors are definitely correct i am away at the moment when i get back i will take the time and recheck all tha earth wire's

2
Omega General Help / Going off 1/3and 5 cylinders
« on: 26 July 2018, 17:55:06 »
Hi everyone really need help have a 3.2 omega i changed the low mileage engine over to a better shell the engine was running like a dream until i changed it over now after i start it/it will run perfectly until it warms up then it going off cylinders 1/3and5 have changed coil packs new and  orginal have had compression test done all cylinders are excellent warm and cold have changed  full wirring loom changed lamba sensors had head gasket checked all ok when it goes off the cylinders when warm after about  5 minutes plug it in clear codes when warm then problem appears again after  5 minutes any help will be greatly appreciated have had a lot of different omega men look at it but no one has the answer ready for the matches

Pages: [1]

Page created in 0.008 seconds with 14 queries.