Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / reservoir sensor wiring

« on: 24 July 2008, 23:48:34 »

Hi all,

i was bored to see ;wash fluid lever error on dashboard.And controled the reservoir but previous owner !! removed the sensor and cut off the cables..There is not any cable to connect to sensor.i need the picture to show that cables or wiring diagram only that part.

Thnx..

97 model, 2000 cd ,opel omega b,x20xev.

2

Omega General Help / Re: Auto Gearbox Selector Switch fault

« on: 06 December 2009, 07:43:21 »

1.      Put the car in neutral.
2.      Remove the selector lever from the mode switch.
3.      Remove the cover.
4.      Loosen the two 10 mm. mounting screws.
5.      By rotating the mode switch you can line up the slot in the mode switch housing with the selector shaft bushing.
6.      Insert a 2,4 mm punch (3/32 in) in the slot.
7.      Tighten the two 10 mm. screws.





Using a multi meter.

1.      Put the car in neutral.
2.      Disconnect the mode switch connector. It’s located in front of the air filter box and it’s the biggest of the three you’ll find there. (black).
3.      Connect a multi meter set to resistance between terminals 1 and 4.
4.      Loosen the two mounting screws of the mode switch and find the range of electrical contact by turning the entire mode switch.
5.      Then fix the mode switch to the middle of that range and tighten the two mounting screws.

3

Omega General Help / x25xev fault

« on: 16 December 2009, 15:00:32 »

2 weeks ago i bought my second omega , its 97 model and x25xev , i have several problems

1-When i made paperclip test, i have 13-135-46-87-48-31 and 144 codes.

most importand is 31-87 , i checked and cleaned crankshaft sensor ,and normally rpm is not working , and heater is not working too.It does not blow out.All fuses are okay.Opel garaga says that ,because of n
o rpm signal heater fan is not blowing out ??.Engine is working fine ,only no rpm and no blow out.Frozen in the car since 2 weeks.What do you recommend ?? What should i do to solve these problems..
And,, 87 =A/C Cutoff Relay Voltage Low

Thnx already..

4

Omega General Help / Re: Automatic Gearbox Fault No drive

« on: 25 November 2009, 17:38:38 »

AUTOMATIC TRANSMISSION
General Troubleshooting


http://www.megafileupload.com/en/file/159768/44generalt-pdf.html

5

Omega General Help / Re: EGR

« on: 17 November 2009, 17:59:29 »

if you blank it off , eml  will light up.

if you do this, no eml light..

6

Omega General Help / Re: Auto gearbox problems

« on: 25 October 2009, 11:22:03 »

And i solved my gearbox problem.i removed the TCM and noticed one line broken ,soldered and no automatic gearbox check light any more...

7

Omega General Help / Re: Auto gearbox problems

« on: 24 October 2009, 13:05:46 »

Yes gear indicators are working and showing the correct gears.Sport switch-winter mode and kick down ,these are not working too.i think its electronic problem.This is left hand drive ,where located transmission control modul ?

i prepared 5 liter gas , final will be wonderfull

8

Omega General Help / Re: Auto gearbox problems

« on: 24 October 2009, 08:56:38 »

 i have same problem ,,My transmission is not shifting automatically. The automatic gearboc check light is flashing as well. It will shift If I shift it into low gear then up shift as I accelerate. If I don't do this it seams like it is trying to take off in 3rd gear and accelerates very slow.

.Selector switch , all solenoid valves ,ATF oil spark plugs,head gasket changed but still same..

Disconnected sport switch and winter mode switch and checked ...No result..

9

Omega General Help / Re: AR25 Automatic gearbox

« on: 13 October 2009, 07:45:58 »

http://scottj.info/files/isuzu/4l30e.pdf

http://myweb.dal.ca/is353832/93fsm/autotrans/44generalt.pdf

http://www.e38.org/electran1.pdf


BMW 318i      L4 1.8/1.9 (1991-1999)       GM 4L30E
BMW 323i       L6 2.5L (1997-1999)      GM 4L30E
BMW 325i      L6 2.5L (1992-1995)       GM 4L30E
BMW 328i      L6 2.8L (1996-1999)       GM 4L30E
BMW 528i      L6 2.8L (1996-1999)        GM 4L30E

BMW Z3/Z3 ROADSTER       L4 1.9L/L6 2.8L 1996-2000)                                       GM 4L30E

[ch305]suzu troppy
honda accura

10

Omega General Help / Re: AR25 Automatic gearbox

« on: 03 October 2009, 15:59:28 »

6 months ago i bought this gearbox ,paid 1450 $

One of my friend sent me gearbox (free)but has no selonoids , i will use my gearbox's selonoids , but need detailed manual.

Now , on high way suddenly appeared -automatic gearbox- check  ... At 1-2-3 and R no problem ,but  at D mode its limp ,what can be reason ?

And , here is bit high !!! , this car is here app 10.000 $ ,how much there ? sure 1000-1500 $ max there

11

Omega General Help / AR25 Automatic gearbox

« on: 03 October 2009, 11:31:59 »

At d mode its very limp  and dont want to go to garage.i need service manual ,is there any link for ar25 gearbox ?

12

Omega General Help / O2 sensors

« on: 13 October 2009, 07:44:35 »

Hi all ,
Paperclip test gives ;130-0130-1110,,0130-0130-1110 .Why 2 times 0130 fault ?
How many o2 sensors are there on x20xev ?

13

Omega General Help / Tech2

« on: 28 September 2009, 06:13:49 »

i want to buy tech2 and found on e-bay ,its in china.
 Price is good but its made in china and clone.Does it make problem ?


http://cgi.ebay.com/ebaymotors/GM-Tech-2-Vetronix-Scanner-32mb-up-to-2010-W-Case_W0QQcmdZViewItemQQ_trksidZp3286Q2ec0Q2em14QQhashZitem23030cdf6dQQitemZ150375030637QQptZMotorsQ5fAutomotiveQ5fTools

14

Omega General Help / 1110 Fault

« on: 20 September 2009, 08:31:55 »

paperclip test gives 1110 fault ,intake manifolt valve.How to fix this error.Where located this valve ?

Thnx..

Omega B , 97 model ,x20xev

15

Omega General Help / Re: KM-Trip counter

« on: 10 July 2009, 21:22:08 »

Okay , thnx a lot..