Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - worzel1

Pages: [1]
1
[moved] [link=http://www.omegaowners.com/forum/YaBB.pl?num=1208472060/0]General Chat[/link] [move by] Auto Addict.

2
hi mate how much for engine, no ancillaries just bare engine? currently waiting for someone to reply about another but not heard anything yet, can collect anytime too thanks

3
hi mate how much for engine block and heads with blown head gasket(s), in present condition, and where are you located, thanks.

4
hi mate you still have engine? after bare block and heads.

5
General Discussion Area / Re: 2.6 problems, help!
« on: 19 April 2008, 12:10:30 »
hi, thanks for the replys. it had misfire before doing head gaskets, when gaskets were done (last week) it had new plugs, all gaskets inc. cam covers, and i've sprayed everywhere with wd40 to try and find an airleak, still nothing. the air mass meter fault code only comes on every now and again but the car is not in daily use, just start it every day, and go for a quick run now and then.
if i leave it to idle the only codes i get now are:
random/multiple misfire
misfire cyl. 1
fuel tank low (got quarter tank)
the other codes i get when driving it, but again not always ( what a crappy fault).

6
General Discussion Area / 2.6 problems, help!
« on: 17 April 2008, 23:41:00 »
hi all, i bought a 2.6 vectra with a misfire (very cheap) only misfires at idle seems to pull through the gears quite well. fault codes have been,
random/multiple misfire
misfire cyl. 1
now and again brings up code (quite rare, been starting it up loads)
misfire cyl. 2
misfire cyl. 6
air mass meter low input
has had both head gaskets replaced due to low compression on two cylinders has had new coil pack on cyl. 2,4,6
any suggestions before it costs a fortune?
am thinking that another sensor is causing misfire as coil pack 2,4,6 is new. thanks in advance.

Pages: [1]

Page created in 0.008 seconds with 14 queries.