1
Omega General Help / Re: Help needed!!
« on: 26 May 2008, 14:22:12 »
gonna give up this shitty engine and trow in a 3.0 v6 instead
- 13 February 2026, 06:28:30
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Re: Help needed!!
« on: 22 May 2008, 21:10:15 »
have changed the crank sensor so its brand new...
3
Omega General Help / Re: Help needed!!
« on: 22 May 2008, 17:00:43 »
tried turning the cams 180deegres but didnt help.....no faultcodes found 
4
Omega General Help / Re: Help needed!!
« on: 21 May 2008, 23:10:18 »
didnt do it the first time.....but did it after i found out how sensitive a v6 was.....vauxhall checked it and said it was correct but i wonder if i have the cams 180degrees out så i will turn them this weekend an will see if it fires then 
7
Omega General Help / Re: Help needed!!
« on: 20 May 2008, 11:56:24 »
ive checked the igniting timing several times and it stands correct....adding av video of my car here:
http://www.speedyshare.com/523821658.html
http://www.speedyshare.com/523821658.html
8
Omega General Help / Re: Help needed!!
« on: 20 May 2008, 10:20:11 »
i have also done a compression test an it was fine...ive changed the entire loom yes
dosent seem like im missin any of those things thats vhats bugging me..
seems like the cars misfiring...
i can post a video later of when im turning the key so you can listen
only fault code i can remember that i got was egr valve but the car should start anyway?
dosent seem like im missin any of those things thats vhats bugging me..
seems like the cars misfiring...
i can post a video later of when im turning the key so you can listen
only fault code i can remember that i got was egr valve but the car should start anyway?
9
Omega General Help / Re: Help needed!!
« on: 19 May 2008, 22:48:15 »
yes, the vauxhall dealer fixed it for me...
10
Omega General Help / Help needed!!
« on: 19 May 2008, 22:28:51 »
hi all! i have a 96 omega that i hace swapped engine from x20xev to x25xe.
when i had the engine out i changed the timing belt, headgaskets, dis pack, ht, spark plugs, crank sensor, maf sensor.
there is spark and the engine gets fuel but it just wont start
had it at vaushall dealer but they couldnt figure out whats wrong...
anyone had same problem? or any ideas?
(sorry if my englidh is bad, im from norway
)
when i had the engine out i changed the timing belt, headgaskets, dis pack, ht, spark plugs, crank sensor, maf sensor.
there is spark and the engine gets fuel but it just wont start
had it at vaushall dealer but they couldnt figure out whats wrong...
anyone had same problem? or any ideas?
(sorry if my englidh is bad, im from norway
)
Pages: [1]