Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / ABS ECU connector removal

« on: 15 April 2012, 16:45:16 »

Hello

I'm having problem removing the ABS ECU connector. There seems to be a purple sliding latch.
Any know where what position the latch needs to be to remove the connector?

thanks
Shakoor

2

Omega General Help / Re: Tech 2 test for speedo stuck on zero and Traction light on

« on: 18 March 2012, 15:41:02 »

thanks for the replies.

The speedo does drop.

One other observation: when on II the traction light goes out but comes back when the engine is started.

Excuse my ignorance but what is PM?

3

Omega General Help / Tech 2 test for speedo stuck on zero and Traction light on

« on: 17 March 2012, 23:54:33 »

Hello
I had the common problem of itermittent abs/traction light on Omega 3.0 litre ellite. Took it to what had turned out to be a dodgey place SINSPEED who claim to be specialist in ABS area.
After their firs attempt at refurb of the ABS ECU the abs and traction light went out and abs and traction controll worked but speedo was stuck on zero.

Since then they tell me they have tested the ABS ECU/pump and ther eis no fault found on it. Ater lousy experience I have no faith in them and I'm not sure they actually did anything at all.
after a lot of cock and bull I have given up with them. The speedo is still at zero and the traction light is back on. The abs works OK.
Any advice where the fault might be?

More importantly, is there esomeone in Basingstoke, Hampshire area with Tech 2 who can run a test to see what the issue is?
And is tech 2 able to pin point problems in this area.

How can I get in touch with Kevin Wood - Alton, Hampshire (On the The boys Pages http://theboy.omegaowners.com/tech2/prices.shtml) as he offers this service?

The engine on the omega is running so fine I don't want to dispose of it for just this fault.

thanks

4

Omega General Help / mechanic to clear breather/change cam cover gasket

« on: 10 January 2009, 00:31:41 »

Hi
I have a Y reg 3.0 litre elite which is leaking oil matching symptoms of breather blockage etc. I'm looking for someone in Basingstoke area to clear the breather and change the cam cover gaskets at a reasonable price and good level of competence.
Any recommendations would be appreciated.

thanks

5

Omega General Help / dot matrix display dead

« on: 19 October 2008, 14:24:51 »

Hi

I have a 2001 3 liter elite. In the last few months a lot of  things have gone wrong, breaks, susspension, tensioner bearing siezer and more costing £2500 to put right. Each time I come back from the garage something else goes wrong. Lost all faith in the garage apart from empty pocket.

Now the ornage dot matrix display panel seems to have died. It is not diplaying anything at all. The radio/cd still works with lesser functionality. I want to try and tackle this myself. Are there any common faults in this area which would cause this? Or is it expensive job of getting a replacement one?

thanks