Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 09 June 2009, 23:27:34 »

Hello All
Good recover in the powersound PCB, did some joints and put back the leaking batteries for test today.

After install did a test on the alarm and it worked fine, now buy new batteries and put glue/silicon to avoid water.
The LED on the front panel still flashing in the first 10 sec  :-? :-? :-? - Perhaps a new setup or reset (? :-? :-?) Any ideas
Well problem partially sorted. Thanks for all helps and replies.

2

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 08 June 2009, 22:47:54 »

Hello Matthew

Tks for the reply I will make the same in mine.
I think also this hot weather is making the batteries leaking.
The leaking caused a nice stain in  the PCB and I need make a good recover. It is possible to buy new batteries and because the corrosion in the PCB lost the money and time.
let's see.

San

3

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 07 June 2009, 23:32:34 »

Hello, Kevin
Bad batteries. 4V and leaking. Replace this week.

Do you know why the led still flashing in the first 10 sec ? All sensor checked OK with the meter.

I will check my car with you soon.

Regards and Thanks

4

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 07 June 2009, 16:31:03 »

Hello, Boys and Girls

Powersound disconnected and open.
Bateries with 4V each but signs of acid leaking going to the device side.
Need dig in to check the tragedy.
Apart from the Powersound the led on the front panel still flashing in the first 10sec. Could be the disconnected power sound ?? or something else ?

Any ideas.

 

5

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 06 June 2009, 16:09:23 »

I'm planning to make a visit to Kevin before a long travel (august). But until there I will check.

This week the alarm started and even turning on the car, pressing the key, etc no way to stop.

I disconnect the battery to solve.

My multimeter will have a lot of work to check all the sensors.



To

6

Omega Electrical and Audio Help / Re: Alarm going ON /OFF - Neighboors want to kill me

« on: 06 June 2009, 01:56:14 »

Tks for reply

I was reading this topic and will check the power sound definitely. The bad thing is take out all silicon I did last week to avoid more water in the spark plugs.

Also will disconnect all sensor and check the light (should be on not flashing in the first 10 sec).

http://www.omegaowners.com/forum/YaBB.pl?num=1203775851/0

More work. 

7

Omega Electrical and Audio Help / Alarm going ON /OFF - Neighboors want to kill me

« on: 06 June 2009, 01:12:41 »

Hello Boys
Need some advice about my alarm.
After close the car and turn on the alarm I see the led flashing 10 seconds indicating something open.
Already checked all sensor (doors, bonnet, boot) and nothing any ideas ?? Also brake light came again after changing the bulb 1 month ago (could it be interfiring in the alarm ??) last week cleaned all the plastic under the windscreen. (water over the spark plugs finally solved)
Any help ??

8

Omega General Help / Re: P0170 + lack of power - anyone had it ?

« on: 08 February 2010, 09:54:48 »

Hello All

I completely agree with Chris.

I should be at Kevin last tuesday and pass the Tech 2 but because I replied Kevin using my email account my message didn't reach him. I lost the appointment.
I need go see him just to make sure everything is fine.

see you all

9

Omega General Help / Re: P0170 + lack of power - anyone had it ?

« on: 07 February 2010, 21:24:02 »

hello !!!

Finally changed my MAF with a new one and everything working fine (until now)

To help others a list with problems:

- Code: P0170
- Car with lack of power
- Start but it fails when driving.
- Clean up the MAF didn't help only stops the light going off.


Thanks for all replies 

10

Omega General Help / Re: P0170 + lack of power - anyone had it ?

« on: 29 January 2010, 12:39:46 »

I want thank you all the guys for the replies.

I will try to get a new MAF soon.  I hope it does not stop in the hard shoulder.

Regards

Sanderly

11

Omega General Help / Re: P0170 + lack of power - anyone had it ?

« on: 28 January 2010, 00:42:26 »

Proz, Thanks.

I got the car this morning going to the work.
Disconnected MAF and start without problems, but foot down and no power.
Came back to park. connected MAF.
Car went normal but no power when running more than 40.

12

Omega General Help / P0170 + lack of power - anyone had it ?

« on: 27 January 2010, 00:29:32 »

Hello all!!

I had the code P0170 twice and cleared it out, took out the MAF for clear contacts and no more alarms but lack of power after 40mph.

Anyone had this problem before ?

Tks

13

Omega General Help / Re: Cambel DVD fior 2.2 Petrol

« on: 27 January 2010, 23:51:25 »

Thanks for the replies and sorry for the ignorance

Can you tell me where can I get the wedge type ??

DVD OOF shop is out of stock. Who can I kill to get one ?

The only thing I used from Halfrauds was the £5 rear bulbs which stop my problem changing it every month.

14

Omega General Help / Cambel DVD fior 2.2 Petrol

« on: 27 January 2010, 01:24:57 »

Hii

Any ideas where can I get one?? Also the lock kit.
Should be done last month.

Does anyone can give a list what to buy ??

Thanks

San

15

Omega General Help / Re: Drivers door solenoid

« on: 08 August 2009, 15:02:27 »

Hello Folks
I had my motor failing months ago and after clean up with oil it came to live again.
The microswith is sealed and hard to open but you just need a small opening to spray swith cleaner inside (2 people job).

After open the motor check the adjustments needed (important)

regards

San